Tackle Box Review Cabela's Advanced Anglers Pro Series 8 boxes inside

Рет қаралды 7,559

6 жыл бұрын

The Cabela's tackle box has finger grips on all the zippers a ton of pockets and eight clear plastic boxes inside that you can arrange any way you want to fit your tackle. The avanced angler pro series is a great choice if you are looking for a new tackle box.

Пікірлер: 17

@sir__waffs3038 3 жыл бұрын

Im debating between the large version and the magnum version of this bag. I'm an intermediate fisherman but which one do you think I should get and do you think I could even fill them? They look like great bags

@dangerfield85 4 жыл бұрын

Good Review - BYOT (bring your own trays)

@alanrobertson2510 4 жыл бұрын

Thank you.

@HKX_ORANGECHICKEN 5 жыл бұрын

Kastking has one like this called the lunker

@grantkelly3126 3 жыл бұрын

Hey I was thinking about picking one up what size trays did you use? Also do you know how many 3700 size trays it could hold?

@CJ-uk9uc 6 жыл бұрын

Can you measure the bottom rubber square for me? The long dimension. Not sure if it will fit in my boat.

@alanrobertson2510 6 жыл бұрын

The bottom is 17 inches long and 11 inches wide. Thanks for watching.

@CJ-uk9uc 6 жыл бұрын

Alan Robertson , Thank you!

@ejdjdjx6727 6 жыл бұрын

I am getting that tackle box

@ejdjdjx6727 6 жыл бұрын

@dwightstewart7181 5 жыл бұрын

*The snaps are an easy fix.* Take the loose ones off and heat the top edge while squeezing the folded front and back sides closer together. You can use either a heat gun or a lighter, but just be careful not to melt or burn the plastic. Problem solved. If a snap doesn't snap the lid down firmly, heat the inside middle of the snap and bend it just a little more. Again, problem solved.

@alanrobertson2510 5 жыл бұрын

Thanks for the tips I will have to give it a try.

@dwightstewart7181 5 жыл бұрын

Alan .. I've done it many times (have lots of these boxes), so it does work. Again, just be careful not to melt or burn the plastic. You want the plastic just hot enough to reshape (near melting) and hold that shape after cooling. You keep holding the plastic where you want it until it does cool. Once you get the hang of it, it's super quick and easy.