I’m building a Tamiya tt02 for top speed. In this video I install the Tamiya high speed gear kit and a 26t pinion from yeah racing. #rccar #rccars #rcbasher #rcspeedrun #tamiya #tamiyamodels #rcracing #yeahracing
Пікірлер: 13
@JoevsRc5 ай бұрын
Nice second run!
@rynks_rc5 ай бұрын
Thanks!
@peterjansen55712 ай бұрын
Get yourself the 55/58 speedgear from the TT01. You have to shave of 1.5 mm and they fit perfect on the original axle. Corraly has the 31t M0.6 pinion. I have a 4600kv China brushless combo for 30€. 119 km/h (75 mph) with this setup. Total cost with a 3s lipo, 75€. Greets from Germany.
@rynks_rc2 ай бұрын
Good info. The plan is 7700kv on 3s and rev it too the moon lol
@eugene2876Ай бұрын
Boom!🤣
@rynks_rcАй бұрын
I still can’t get that trick to work lol
@gronkvbs27954 ай бұрын
They're not Phillips screws. Get a Tamiya tool set. ;)
@rynks_rc4 ай бұрын
I been replacing them with Allen as I take them out and throwing those junk screws in the trash lol
@kanenstuffАй бұрын
I never use Tamiya screws I just go hex hardware, which is not good as I invented in the Tamiya screw driver kit and wil never use it ha.
@rynks_rcАй бұрын
Whenever I go through any older nitro cars or trucks that have the Phillips head screws I buy the stainless hex hardware kits. Not a fan of that hardware ether
@kanenstuffАй бұрын
@rynks_rc high tensile stainless steel or 12.9 hardness steel is always good. I don't use aluminum screws, though they look nice with the colours they strip too easy and over priced.
@rynks_rcАй бұрын
@@kanenstuff I buy the kits from RC screws. There alittle soft if you go hard on them but for under $40 you can’t go wrong and the amount of extras they throw in really go a long way
@kanenstuffАй бұрын
@rynks_rc that's good I'm an Australian working in Malaysia we have great quality stuff. A hex kit is 30 MYR or 30 AUD for 200pcs for and assorted pac so it's a bit of bargain like our 40 cents per litre petrol/gas.