I'm about to change the belts on my RS-615US, so this is very useful video for me. The only negative criticism I can comment on, is the music. It's unnecessary, it's loud, and detracts from your speech and the important content of the video. That said, thanks for taking the time to make this video.
@ClassicHiFiReviews3 жыл бұрын
Hi Max, yes that was one of my first video. Hope this improved with my later ones. I got a few more vintage Technics decks lined up for restoration.
@maxedison82593 жыл бұрын
@@ClassicHiFiReviews Hi, I've just changed all three belts on my RS-615US and it sounds great now. I was far more confident in tackling the task after I had seen your video, so thanks again!
@imtheman30395 жыл бұрын
Hell fucking yeah this helped me on my Onkyo TA-2056. I used an aftermarket belt from eBay and that belt was a bitch to get to. Got it dialed in and working like a champ now. Thanks!
@m801167 ай бұрын
Got one of these machines RS 615 (EU) and immediately upon inspection I noticed the massive capstan wobble... I've never seen a capstan bearing so worn out in any other decks that I've put my hands on. But apart from that the machine still plays nicely when the bearing is tensioned by the pinch roller pushing against it. Just by lubricating the bearing it has become smooth, it was rattling inside the housing before. I can't really stand the sons of a dog that use these machines without even lubricating the capstan bearing. It wasn't supposed to be re-lubed for 1000 hours after it was made, and a service life of 5 years regardless of hours. It's 50 years later you have to LUBE the goddam bearings!
@emteiks4 ай бұрын
thanks for sharing!
@walkmanmasterКүн бұрын
Nice. what deck did you use for reference to record test tape ?
@blade31202 жыл бұрын
YOU MADE BIG MASTAKE PUT WRONG BELT! REPLACE THE SPECIFIC BELT! DO NT TUCH THE PICH THE PICH IS CORRECT!
@redfelipe65654 жыл бұрын
Very interesting video, thank you!
@BriansModelTrains5 жыл бұрын
great video - really fun stuff
@jorge1955012 жыл бұрын
Thank you for your video, demagnetizer is before adjust the speed or after ? Thank you again.
@lachlanlau2 жыл бұрын
Does not matter
@mrt60london575 жыл бұрын
Hi do you know what voltage the Tape Deck lamps are Thanks..
@ovidiualba96484 жыл бұрын
Not in this particular model, but usually 6 volts, 68 mA, grain of wheat bulbs, or might be different, that's what i got in mine one
@ovidiualba96484 жыл бұрын
Hi there Just wondering if that oscilloscope will be ok for head alignment, got two options the model you are using and an old tektronics 2440, what would you recommend? Thank you
@DoNaSbaR Жыл бұрын
Swapping a flat belt for a square one, absolutely not.
@kimkennedy63172 жыл бұрын
Im okay with everything except making the tape on a known good machine. No way . Disassemble a cassette and measure the perfect exact amount for a 3 minute run. Reassemble. Unless you get this correct, all bets are off you are assuming.