Рет қаралды 52
If you are tying to troubleshoot the PLL in a Paragon I then a freq counter should see 2.1 MHZ exactly on Pin #1 minor and major loop boards. Pin #8 from the VCO's is a different story and this video show typical frequency values from a working Ten Tec Paragon I.
Pin 8 is the frequency from the VCO running and in some cases this frequency has been divided or mixed on the reference board.
Due to dynamic division in the PLL chip sent in serially from the microprocessor this frequency going in in pin #8 really varies and is never ecactly equal at least on the outside to 2.1 hmx on Pin #1