Great follow up video! :) Mine hasn’t had the blob of death yet either, and i’ve used it daily for an entire month now. I really enjoyed making the Celtic Cube from thingiverse, so maybe give that a try. I have 8 colors already too now. Addicted

I’m using Orca Slicer, and it’s been great! Took some settings from over 3 videos and fine tuned it. Learned to glue the plate every time, after a piece broke free at 90%, and also bought some Gloop for bonding pieces together too.

Sweet

Hey pal nice video. You explained the faults and possible reasons. No BS, no fluff and I bought the same printer roughly 2 months ago and software was updated as well. My only issue is I nicked the ribbon cable. They sent a replacement and I fixed it. Elegoo has be responsive and helpful. I did accidentally delete the Webcam.txt file and didn't know it so I did lose the ability to put the Webcam on it like I had plugged into the usb and went through KZfaq videos on how to enable with putty and ssh talk into the printer. I am first time printer guy but am pretty techie and even after redoing all the firmware can't get it to recognize a Webcam. So... Be careful in fluid with the folders and files. I haven't printed anything but PLA but want to print with some stronger items made for an enclosure if you had any suggestions I'd appreciate comments. I've had very good luck with all speeds and updated to elegoo version of cura 5.6 from their site. Keep experimenting and post failures as well because I get tired of seeing the professional time lapped vids that always are perfect. Go Elegoo!

I have some problems. I dont know what exaclty it is but all my cura support prints failed. I want to print helmets but everything big fails some times after the first layer. Im a noob and idk ps: benshi and Buddah seem fine

I do not know how good filaments printers elegoo do... but their aftersale support is great

On the grey benchy, try using high-speed/rapid pla.

Drill a hole in the centre of the stuck bit, put a screw in it and pull it out.

Nah railed out soon is wild!

My neptune plus got send back. It dragged on the part, with gcodes that came with the printer. it could not connect to wifi adn teh z-sensor died on day 2

was that a cg5 refrence

I was so enthusiastic to buy this printer model. After a month of use all hell begun... After a blob of death everything went pear shaped. I've got the replacement print head no doubt, but the next one couple of days later... I was so angry, I've just throw it to the bin... No replacement from this company. Since the installation and re-levelling of the latest pre-assembled extruder kit I was not able to print a single usable piece. As the latest repeated fails, I've checked the bed temp and found that: it is all over the place and some parts even 10C degree lower than the set level. I wasted countless hours and countless filament reels with this junk of a printer. Not happy at all! Wouldn't ever buy another elegoo in any shape or form.