similar experience. i'm normally a dewalt guy, but opted for the milwaukee framing & finish nailers. Not sure whether this helps, but at least for me, the weight of the Milwaukee has been manageable: I've been using the little 1.7 ah Powerstack Dewalt batteries with a cheap amazon dewalt-to-milwaukee adapter, and just swap batteries every couple of hours. The adapter weighs almost nothing, and those little powerstack batteries are really convenient. I definitely wouldn't want to lug around a 6ah battery in the milwaukee. good review!
@nosnim22073 ай бұрын
Dewalt just released their next gen framing nailers FYI. Models DCN920 (21-deg.) and DCN930 (30-deg). Supposed to be a big improvement than the one you have there. More power 💪 (to drive nails), can toenail 🔨 better, no need to wait ⏳️ for ramp up and etc.
@Southernhomesteads3 ай бұрын
I will have to look for that. If the dewalts didn’t jam and have to be disassembled to clear it they would have been my favorite.
@nosnim22073 ай бұрын
@@Southernhomesteads Yep. Forgot to mention it's lighter than prev gen too! 😄
@christhames21752 ай бұрын
@@SouthernhomesteadsI just bought two of the DCN930 guns less than a week ago, to replace my DCN692 guns. My 692s have been good and have lasted several years, with some jams along the way. These new 930s have me looking into other brands. I have shot a couple thousand nails through the 930s and they shoot great. However, when the trigger is pulled, in any mode, the flywheel spins under power for 20-30 seconds after release. This has made me change batteries twice as often as before. The batteries are always overheated when it's time to change them, and yesterday one of the guns overheated to the point where it wouldn't work until cooled down. That happened after running about 30ft of 8ft wood privacy pickets. So it took roughly 500-550 2in nails to over heat.
@eddieosteen2134Ай бұрын
Just purchased a freeman 21° had to get the adapter to fit my DeWalt batteries but together only 220$ so imma see how it performs. Could be a cheap alternative
@jhipplАй бұрын
ohh i didnt know they had one, i use the ryobi nailer and its great but im not beyond adapting from flex to freeman
@francocalcagni93233 ай бұрын
Great video. Some YT reviewers use point systems, other are just subjective opinions. I think jamming every 20th nail or so, versus never jamming is worth more than 4 or 5 of the other criteria. If I am using a nail gun and expecting to drive a couple of 100 nails, feel, weight, buttons and many other things are only so important. Having to deal with jams and the time to unjam; I could NOT work with that. Your conclusion is what I would also come up with if I experienced the same, in using these 3 guns. Jamming as often as you say for the Dewalt, is a non starter. Can't work with a gun that keeps you from working. Heck, I would probably go back to a hammer rather than use that Dewalt...and BTW, I do not have a trailer full of Dewalt, but do have quite a bit and generally am a fan. Probably a close 2nd to Makita overall brand that I have confidence in.
@Southernhomesteads3 ай бұрын
It’s a bummer, Dewalt has made it difficult on some of us in the trades. We really wanted to stick to just one battery system but they have had a couple of huge misses and have forced us to venture into other brands. As a follow up we now run two Metabo guns and just did 2 boxes of nails over a couple of days and never had a single jamb.
@thaddeustroyer3 ай бұрын
Ridgid has a battery powered framing nailer. They also have a lifetime warranty on their nailer AND batteries! Who could ask.for more? Just kidding, i agree with everything you said on your review juat wish you could have included in your review. On the metabo nailer battery issue, you need a bigger battery, that 2 AH batter is stoo small and Doesn’t have the power to run the nailer long term.
@Southernhomesteads3 ай бұрын
Thank you for the insight! I will see if we can get one of the rigid and see if we can do a test on one of those. The battery we are using in the metabo is the battery the gun came with. We will try a bigger battery.
@thaddeustroyer3 ай бұрын
@Southernhomesteads awesome, would love to see what you think. Metabo, ya I know it's the battery it came with, Ryobi does the same thing. It's enough to get you going and I appreciate that from Ryobi and metabo, but it just doesn't have the guts to work Long enough or properly, it has to do with the "stored capacity" in the battery ( amp hour rating) it has been my experience that you need a 4 AH or greater for best performance. Good luck and thanks for the review.
@nosnim22073 ай бұрын
The Rigid is nice. It's a rebadged AEG and the great thing is you can easily add/refill the air in it when the nailer starts to not drive nails in well. The Metabo and Milwaukee you usually have to send it in to factory and pay for a top up.
@joaquinchan9936Ай бұрын
None of them are perfect, but Metabo seems to be the most reliable of the bunch. My biggest issue with the Milwaukee is not having the option to self charge the chamber with compressed air and that's a bummer. The Metabo gives you that option for all their cordless nailers, but their finish nailers aren't powerful enough to go on the tool trailer.
@GannDolph2 ай бұрын
hoping you do an update video sharing your impressions on the new Dewalt once you get your hands on it!
@dannym67017 күн бұрын
When the DeWalt jams like that just roll it off the nail like a claw hammer flick the lever across and then press the striker with your finger tip and it'll reset, takes seconds. But I've found to stop those jams, take off the service springs and oil the two long pins and oil the springs before you put them back on, it will transform the gun!! Be careful not to get oil onto the firing pin though!!
@varga13zsolt3 ай бұрын
Great review, I have the 30 degree dewalt and metabo hpt. I agree that the dewalt is well balanced and easy to use , on the other side very sensitive to what nails use, with some brands will gem up and that hook is not my favorite.
@Southernhomesteads3 ай бұрын
I have debated on the 30 degree going back to the pasload. I would use one back when it was the only cordless option. The only issue is it doesn’t bump fire at all which makes it tough when you are using it for more than just pick up work.
@bobsundquist2039Ай бұрын
A quick check and there is a $20 adapter ao you can use Makita batteries. Might have to get one.
@renurenovationsllc778024 күн бұрын
I have bought 3 Hitachi 18volt and the original ones in bump fire mode, would also single shoot. After battery prongs wore out, bot the gun, I bought 3 Metabo HPT 36volt guns, more power better rafter hooks, soft shot, AND THEY WORK CONSISTANTLY, and I have the adapter to add air after a couple years, and a couple HUNDRED THOUSAND NAILS. I wanted to like the Milwaukee since we have all 6.0 Forge batteries. So I tried two, one was at the shop already, they have a REALLY harsh recoil feel, are heavier, and about the time I think I am over it, I pock up the Metabo HPT, and shoot one shot, and I know I will never like the Milwaukee
@jeffc-vy6vh3 ай бұрын
Good info!! Thank you
@Southernhomesteads3 ай бұрын
You bet!
@realworldcarpentryremodeli58683 ай бұрын
I’m a dewalt guy as well but cannot bring myself to use thier cordless nail guns. They all have the same issues. The finish guns are junk. Constant jamming no matter what nail brand you use. It’s frustrating. We still use our paslode gas and battery guns. They are light and dependable. The gas sucks but the guns work consistently . I hope dewalt can work out their issues.
@Southernhomesteads3 ай бұрын
I totally agree. I am told the new pasload will come with bump fire. if it does I will probably go back to them.
@anthonyturner53192 ай бұрын
Paslode is nothing but trouble and maintenance, I’ve had a good run out of my dewalt nail guns, gen 1 and gen 3 put 10,s of thousands of nails thru, more power and fires faster I leave it on rapid fire setting which keeps the fly wheel going longer after each shot, less noise no gas smell and lighter than Milwaukee and hikoki, but crap belt and rafter hook. I’ve got 5 different battery platforms so no fanboy of 1 brand.
@LuisHernandez-iz9hz2 ай бұрын
thank you for your information
@Southernhomesteads2 ай бұрын
You are welcome
@robertpietras2956Ай бұрын
What about Ryobi?
@markgross3256Ай бұрын
Are you going to try the new Dewalt?
@SouthernhomesteadsАй бұрын
I might when they are available here. As of now they are still selling the old ones locally.
@michaelklinger3952 ай бұрын
Why no craftsman???
@illmagnetic29 күн бұрын
It's a DeWalt in red.
@michaelklinger3952 ай бұрын
Craftsman’s cheaper and just ass good if not better then all 3