The Unimat 3 Motor and Drive Belts

Рет қаралды 4,090

10 ай бұрын

If you own a Unimat 3 lathe and wish to make your own drive belts, replace your motor brushes or repair your motor (in the event it has developed a fault) - then you may find this video useful.

Пікірлер: 12

@T3glider 7 ай бұрын

Clear and complete. Thanks.

@madsighntist14 6 ай бұрын

Thank you, from the Great Pacific NorthWET, Oregon Division. I do not ~own~ a Unimat, but I do follow most every "small lathe channel" that I can find. Your Very controlled voice reminds me of my days in Avionics Radio Repair, and I deeply appreciated your comment on your qualifications to do motor repair. I have left behind ANY & Every utube channel that I see doing Unsafe Work, AND leave comments on WHY! Hopefully NEW machinists, will be thinking on that. at 73 years of age, I have dropped from 19" Diameter Swings with Seven foot long beds, to my Proxxon M150 that can do 4" long! I use the Proxxon M-70 milling machine, and design my own cutting tools from 7 1/4" carbide tipped (new) saw blades: 24 carbide tools, for approximately $12.00 U.S.D. I have not started a Utube channel, but imagine milling "a bar" length as needed, and either a left hand, or right hand Carbide to cut with! Yours, From up above the equator, Philip, AKA, the madsighntist.

@downunder4087 6 ай бұрын

Thanks Philip. I really appreciate you taking the time to comment. I'm in the early learning stage as far as making videos is concerned. Truth is, I hate seeing myself on screen and am not keen on hearing my own voice either. Putting words on the screen seemed the only solution but then I found there was too much I wanted to say here. BTW - I'll be 72 this year so we're around the same age. Wishing you all the best for the new year. PS. You're well ahead of me in being able to design and build your own carbide-tipped cutting tools! That would certainly ne worth seeing.

@kayerickatson4814 8 ай бұрын

Thanks for taking the time to make this informative video!

@downunder4087 8 ай бұрын

I'm glad you found it useful. It makes doing it feel worthwhile. 😊

@Rhythm_King 10 ай бұрын

FYI: I found I had to increase my video quality to 720p in order to read the information on screen. Hope this helps others watching.

@downunder4087 10 ай бұрын

Thanks. I'm often disappointed with KZfaq video quality and I've never been sure how many countries are affected by it. I wasn't even aware I could alter it at my end until now. 😊

@RustyInventions-wz6ir 5 ай бұрын

Just found your channel and Subscribed. Very nice lathe

@downunder4087 5 ай бұрын

Thank you. Unfortunately you won't find many new videos appearing. I'm still enthusiastically working on projects but it takes me a tremendous amount of time to do a video and other things are much more pressing at the moment. 😊

@41815 8 ай бұрын

Thanks for all the drive belt tips! How does one replace the power drive belt? Ir wont go over the headstock pulley

@downunder4087 8 ай бұрын

That headstock pulley should easily unscrew off the headstock spindle. Just use one hand on that pulley and one of the two little steel rods you use to adjust the jaws on the 3-jaw chuck to hold the spindle from moving.

@41815 8 ай бұрын

Thank you!