Remember to SUBSCRIBE to see more videos, support the channel by sharing with friends and COMMENT about your favorite content for Kid Toy Tv to do much more video for you. THANK ALL OF YOU SO MUCH.

The video is very good. I bought a servo and a board soon I will install it on it

Mantap bang keren 👍👍🙏

Good 👍

Nice

nice movie. did maximum lift force increase? how much weight can it handle now?

Esta super el vídeo por favor modificada una volqueta

Wiring it back up how did you do it

Hello, is there a better battery pack for this toy? One that last longer or gets a bigger output? Thank you

Very nice video i liked and subscribed :) i have a question/comment. Why didnt you lock the gears or not lock the gears even and leave the original mechanisms in place as a secondary power source. If yoiu match the speed you can lock the gears and add even more force more power to the boom stick and bucket

i have a huina 1550. but the receiver is broken. if you just change the receiver without changing the remote, can it turn on or connect the old remote to the new receiver?

How do I connect cable servos ?? Please answer

where are the wires connected to the motherboard and what battery pack is that?

How much stronger is it actually ? Iam looking to install them into my 1592

Hi there! Great video, just one question... How did the wiring go? Was it easy to do?

0la como é que eu faço para montar tracção a traz maquina huina 1550

Were did you get the servo actuator upgrade kit??????.

You didnt show how to connect the wires which wires o b the excavator go to which servo

I did the mod to mine! The video is located at: kzfaq.info/get/bejne/gLaGf5ek1cinm4k.html While I had it all open I reassign the arms to a more logic connection to the joysticks. Only one motor had a capacitor across its connections, very bad thing to leave out. When the field of the windings of the motor collapses it induces current back in and can burn out the controller electronics. Now all motors have a capacitor to protect it. Also, all wiring is inside the arms, and I put long enough runs so nothing is stressed. Those actuators are so strong that I added another pound of fishing weights on the opposite end of the machine. Now it stays level and does NOT tip in any direction. So far I have been able to lift 10 pounds of fishing weights! This machine is so powerful not that I could actually trench a water pipe in my yard, it would just take awhile, but can be done! I have a logger and truck crane that I will be doing the mod on also! My excavator is a lot different that yours on the inside, but no problem for me to mod, I'm a retired electronics instructor/engineer and this is childs play for me to mod. However, I sure wouldn't recommend to someone who doesn't know how to solder, and have enough brain power to figure things out. Before the mod I couldn't dig wet sand, now I can, as well as, dig very dry and hard dirt!!!

Bắn vít xuyên servo không sợ nó hỏng bánh răng servo hả ah

Your link is incomplete, I tried it got a 404 message, might want to finish the link so it works correctly.

Can I buy one of your excavator please ?

Lâu rồi ko gặp anh

In the sand break all

Oya motar vargaya mokadda

ভাই এগুলো দাম কত

Your hands hid most of your work couldn't see exactly what to do