Thor with the new Holmes Crawlmaster Mini V2 is AWESOME!!

No video

Thor with the new Holmes Crawlmaster Mini V2 is AWESOME!!

Рет қаралды 8,915

Күн бұрын

V2 CRAWLMASTER MINI IS AWESOME!! Specs below!!
holmeshobbies....
Holmes Hobbies motor recommendations:
Crawlmaster stubby 2700kv max 4 cell
Revolver 2500kv 10 pole max 4 cell
Revolver 2500kv 14 pole max 3 cell
The CrawlMaster Mini ESC is a new ESC designed for the needs of RC Rock Crawlers! The v2 design adds an internal BEC and larger mosfets for stable use on 4s with higher KV motors. It harnesses the power of 32 bit technology to offer the smooth, quiet, and torque dense driving you desire in an extra small package! The ESC is bare and not soldered or waterproofed, so you can make your wires the exact length needed for custom installs. We recommend coating with silicon conformal if you plan to run in wet, moist, or dusty environments.
RECOMMENDED USE:
1/10th and smaller Single speed Trail, Scale, and Rock Crawlers such as TRX4 Sport, SCX10, Element Enduro, etc..
Recommended 8lb limit, subject to gearing, driving style, terrain, etc.
NOT recommended for two speed vehicles, rock racers, tow rigs, and other high load installations.
FEATURES:
32 bit processing power unlocks advanced control algorithms and future upgrades
Exclusive Sinewave Startup (like FOC) but open system and compatible with all motors
Silent operation with most motors, inaudible switching frequency
Intelligent RPM lock at low speed for unmatched control when it matters most
Normal "PWM" throttle above startup for predictable power output and less broken parts
No on/off switch to fail. Plug it in and go!
Overcurrent, temperature, stalled rotor, and throttle loss protection
Automatic cell detection and low voltage protection for LiPo battery
Ultra smooth throttle and strongest drag brake out of the box
5 volt 2.5 amp internal BEC
SPECS:
3 to 4s lipo (20v max)
40a continuous operation
Dimensions: 38 x 27 x 4.6 mm (bare board)
Weight: 7g (bare board)
INCLUDES
Bare ESC
RX wire (not installed)
Heat Shrink
Power capacitor for 4s use
Spare Times Hobbies Chassis
sth.ecwid.com/...
Spare Time Hobbies Optimus Bundle
sth.ecwid.com/...
JConcepts Tucked F-250 Body
Amain bit.ly/3u70Lu1
Horizon bit.ly/3OGgZVL
Holmes Hobbies Revolver Motors
Holmes holmeshobbies....
Amain bit.ly/3Bes2xT
Proline Trencher 2.2
Amain bit.ly/3krF9FG
Horizon bit.ly/3LuBTVG
Amazon amzn.to/37NLmsN
Holmes SHV 800 Servo
holmeshobbies....
Ebay ebay.us/37CBfC
CHANNEL MEMBER INFO
If you would like support Exocaged RC Directly, consider being a channel member. Cheap monthly membership fees, they are $1.99, $4.99, $9.99 and for the big guys $24.99. Take a look! / @exocagedrc
Want some AWESOMELY BADXXX SHIRTS!!! Check these guys out Armed American Supply ( I'm an affiliate with them now )
Get Upside, I use this every time I fill up and just let it earn till Christmas time and cash out. It works and once you get used to it, it’s an easy habit.
Click this link or use promo code 9H6W8 to get an extra $2.22 bonus the first time you
make a purchase. upside.app.lin...
#rccar #crawlmaster #thor king

Пікірлер: 47

@ZSMracing 2 жыл бұрын

That was the coolest line I’ve ever seen😂😂😂👍🏻

@cocoAE86 2 жыл бұрын

Epic pipe line

@jasonrieman1973 2 жыл бұрын

That line that you were talking about calling Thor should be called Asgard!

@RIDEROFTHESTORM-in6pt 2 жыл бұрын

Roll up on the scene with that BEAST! Instant street cred👍🏾👍🏾👍🏾👍🏾👍🏾👍🏾

@JPWirt 2 жыл бұрын

Joe! That line on the pipes was CRAZY AWESOME!!

@danwoodruff4323 2 жыл бұрын

The pipe crawl was epic. Need to call it ( Pipe line).

@ConsciousnessAndScience 2 жыл бұрын

mine should be here tomorrow. and also grabbed a 1400kv snubnose to complement it. oh boy.

@rustysglass 2 жыл бұрын

Man that was wicked cool that was an MOA line right there!!!!

@ExocagedRC 2 жыл бұрын

Thanks!

@jerryvolpini7987 2 жыл бұрын

The sound if silence! Great little ESC, lots of power and tons of low speed control ! I mean, that crawl over the pipes, just crazy! I think John might have a winner there 🤔 😉

@creekcreeperrc7972 2 жыл бұрын

HOLY SHIT!!! Talk about hardlines.. 🤘🏼

@ExocagedRC 2 жыл бұрын

Yep!

@creekcreeperrc7972 2 жыл бұрын

@@ExocagedRC Sure you hear it all the time, but Thor is my absolute favorite build that I’ve ever seen hands down! Wonderful build and driving sir👍🏻👍🏻 and thank you for all the great content!

@erickrzanich8000 2 жыл бұрын

Your driving always impresses me.

@brianellison3525 2 жыл бұрын

Waiting on the mail, my mini esc should be here today! Thor is one fine rig. Have fun man.

@johnharris4738 2 жыл бұрын

That pipe crawl was awesome! 👌

@sammyboswelldirtybrc7580 2 жыл бұрын

Thor is awesome

@majorrhodes2870 2 жыл бұрын

Got one word for that crawl WOW 👍👏

@sebas888888 2 жыл бұрын

Being also from the IT and maker world, I would and normally apply conforming liquid at the very least since it's a nice water resistant cover. But where I live or crawl there's just so much water and all that I end up covering boards with two part five minute epoxy , (plus heatshrink if you want why not) . This is both a good way of protecting against shorts and has the added advantage of holding everything together. Ok if you want to repair or change things it's going to be a bit more difficult, but not impossible because you can still pry it apart with a bit of conviction and an exacto knife , more or less .. But since you mostly drive on dry rocks it might not be so much of a big deal for you.. Anyway take care, peace ✌

@pooljunki1 2 жыл бұрын

badass

@andrewdecavia7553 2 жыл бұрын

If you hardwire it, like John did when showing off the upcoming piggyback system for these, you may need the AM32 (Action Manager 32 Programer) to reverse rotation of soldered directly to the motor. Most will likely wire it like you did, but just in case it comes up it’s good to know these AM32 are quad programmers so you can find them at some places that sale quads or wait and Holmes plans to eventually have some in stock

@attuti 2 жыл бұрын

🧼 clean

@endosrc 2 жыл бұрын

Have you ever thought of soaking your crawler tires in simple green and letting them sit in a bag for a few hours like the no prep guys do. I think it would be a good experiment to try

@nathanbaldn8childs125 2 жыл бұрын

Where is it that you test your Rigs? This place looks fun as hell and im thinking I wanna build something to crawl in the backyard just like that place

@brunomortier9250 2 жыл бұрын

belle performance 👍👍👍bravo

@blakedenley3792 2 жыл бұрын

did you check temps after running?

@cyclonerc1625 2 жыл бұрын

Thor the amazing 🦍 lol. Thank's for Sharing Joe. 💯💪💯👍

@dkmgm2011 2 жыл бұрын

The pipe bridge gap was nasty.

@jackfrost994 2 жыл бұрын

Put scx 6 swampers on Thor, im doing it with my smt10 and ryft axles

@RuisRcAdventures 2 жыл бұрын

Great session Joe, that Thor is an epic build mate. How about calling that spot Thor Point? 😁 Could you please remind me what tyres are you running on Thor? Cheers 👍

@nickdaniels9680 2 жыл бұрын

The tires are Pro-line trenchers 1.9's, Cheers.

@matpickermcfly3103 2 жыл бұрын

This rig is awesome! Whats radio are you using for all the function you have?

@johngookinsable 2 жыл бұрын

You could name this side of the pipes" monkey bars "

@broken4999 2 жыл бұрын

Sick rug bro, what chassis is that?

@augustzackery 2 жыл бұрын

Need a build breakdown on Sam

@bjrnarrosseland9012 2 жыл бұрын

Runs good:) Same 2200kv motor?

@johnnymckissick2735 2 жыл бұрын

That pipe line was insane! Hows top wheel speed with that esc?

@jdsrcs8061 2 жыл бұрын

You need to install some web shooters or a grappling gun and change his name to Spidey!!!!

@jdsrcs8061 2 жыл бұрын

Call that new line The Spider Walk

@benfred8 2 жыл бұрын

I’m gonna go look but would you do some dual steering set up? With the gt5? Also would you demonstrate how to have button activated rear steer? I’ve heard that you use that option instead of switching through a four steer menu. Specifically with the gt5

@benfred8 2 жыл бұрын

And thanks for the content bro.

@AllOrNoneR.C. 2 жыл бұрын

It really seemed like the linear curve on that for your throttle was quite nice. Definitely something I'm going to have to check out because I have a 3000kv three brothers racing motor but I'd like to put in a crawler

@brianellison3525 2 жыл бұрын

Make sure you look into dropping the pinion as far as you can go, and getting a big spur gear. My last comp, I was using 1800 kva on 3s. I use an 11 /56 combo and still have all the wheel speed i would ever want and 3000 is way outside the range recommendations for themini esc he is using. Have fun man

@brianellison3525 2 жыл бұрын

That's a fast motor for a crawler,