No video

Tint Removal 4 YEARS Old - How Did It Come Off??

  Рет қаралды 53,012

CK Wraps

CK Wraps

5 жыл бұрын

Removing Vvivid Vinyl taillight tint after being installed for 4 years.
Get the light tint here amzn.to/2U4fUu7
Get 70% isopropyl alcohol here amzn.to/2ErcE6s
Get 3m 301+ masking tape here
amzn.to/2Iwa3uL
Sign up to our mailing list on www.ckwrapstor... to receive special offers and updates on new products
Certified Training visit www.vvividhq.c...
Email nav@ckwraps.com to save 20% on your Vvivid vinyl order

Пікірлер: 43
@jaluna06
@jaluna06 5 жыл бұрын
Definitely see where I messed up. LOL. I recently tried to remove the Vvivid vinyl from my headlights and did not heat it. It came off in chunks and left ton of glue. It sucked. I ended up buying new headlights. lol. Thanks for this tip.
@ducebigalow8834
@ducebigalow8834 5 жыл бұрын
what is on your rear window, it looks like either water or some sort of a texture?do you put clear film on front headlight/fog lights (civic hatchback)?
@andreww1212
@andreww1212 5 жыл бұрын
Nice Gen Coupe! I got one too. Such a great car.
@tedcain8317
@tedcain8317 3 жыл бұрын
You may have saved me several hundred dollars. Will try this instead of replacing a tail light on an older low production car.
@Candyman2020_
@Candyman2020_ 5 жыл бұрын
Sadly my vivid lasted less then a year. Purchased directly from vivid. After 1 year in the sun it browned a dark haze and took hours to remove as it cracked into little pieces
@ArizonaGuerrilla
@ArizonaGuerrilla 4 жыл бұрын
What did you use to remove it
@akhenatenra2841
@akhenatenra2841 9 ай бұрын
That nightshade purple is Fiiire
@djsonfire0001
@djsonfire0001 5 жыл бұрын
Can't wait to see this new tint with a design go on
@Aepek
@Aepek 5 жыл бұрын
How long would recommend leaving the taillight tint on for cars in Florida (central & southern); since you know the temps we get here😉 Thanks for the vid & info....hope you reply 👍🏻 Cheers✌🏻
@poodieac
@poodieac 5 жыл бұрын
Sold on wrapping my car after watching your videos. If you were in LA, I would have you do it.
@paulquintero8295
@paulquintero8295 5 жыл бұрын
Vvivd must send you the good stuff! Every removal for me left excessive amount of glue even after a year. Luckily tho, 70% alcohol cleaned it up.
@oHITMAN14o
@oHITMAN14o 5 жыл бұрын
Paul Quintero tac reducer
@paulquintero8295
@paulquintero8295 5 жыл бұрын
o HITMAN14 tac reducer for complex curves? No thank you. I use that for high tack KPmF and 3M
@oHITMAN14o
@oHITMAN14o 5 жыл бұрын
Paul Quintero you don’t gotta spray a lot just one tiny spray. I took mine off in one piece with no glue at all without heat. In the Texas heat
@paulquintero8295
@paulquintero8295 5 жыл бұрын
o HITMAN14 o I switched to Lux tints. But good tip for sure
@oHITMAN14o
@oHITMAN14o 5 жыл бұрын
Paul Quintero I haven’t tried anything else but vvivid. No problem . Lmk how that goes for you
@JelenaMaticserbiangirlingreece
@JelenaMaticserbiangirlingreece 4 жыл бұрын
Hey I wanted to ask, what is the temperature for the heat gun? Also many told me that glue can be taken off with gas? Like first to use gas/ petrol and then to use liquid detergent? What is your opinion?
@UNKA757
@UNKA757 5 жыл бұрын
What is all over that car Christian? Did you park in a pile of mulch? LOL. Great Video, thanks for the Information!
@augustinedeering7703
@augustinedeering7703 5 жыл бұрын
in my experience, even when using heat it would leave a lot of glue
@aussieflyer70
@aussieflyer70 5 жыл бұрын
G'Day Christian hows things mate, love the color on your car, looks awesome....take care mate...cheers.
@madebyscratch
@madebyscratch 5 жыл бұрын
still waiting on VVivid to send my sample of nightshade purple.. I hope that it looks as good in person as in these videos.
@mohamadfauzi2917
@mohamadfauzi2917 3 жыл бұрын
Mine became too hardened and brittle.. coz it’s more than 4 years.. still can’t figure out how to remove it..tried hot water and hot air.. just won’t come off.. scraping with knife takes a lot of hard work and patience..
@ronnydisalvo80
@ronnydisalvo80 Жыл бұрын
I just took same tint off my headlights . Did it myself. Removed using heat gun also. Have a lot of glue to remove..assuming this happened because it’s under 50’degrees here in ny, any suggestions on glue removal?
@guillegm96
@guillegm96 2 жыл бұрын
Is it posible to remove factory tint from the rearlights?
@richardr.724
@richardr.724 2 жыл бұрын
What chemical would you recommend to use if it would have left adhesive after remove the vinyl from the taillight???
@rickhoffman7656
@rickhoffman7656 2 жыл бұрын
thank you so much
@DavidHowardPhoto
@DavidHowardPhoto 2 жыл бұрын
If possible how do I remove a white crispy baked on headlight tint. The rest has come but on the bmw e60 it's left a line all the way across the top with a hard crispy tint. Any advice?
@raulosvaldomomzon7152
@raulosvaldomomzon7152 5 жыл бұрын
I have a genesis coupe to, how did you install the reverse camera?
@MxT333
@MxT333 5 жыл бұрын
You do your front ones? I bought some vivid light smoke ones off Amazon and it peeled the paint off the trunk and ripped in my hand like a piece of paper.
@mohammedpatel6336
@mohammedpatel6336 5 жыл бұрын
Mask around the taillights and headlights when tinting. It brings down the surface area where it would like to stick to. Always apply in room temperature and apply heat before stretching. Should fix your issues you had.
@assyrianme
@assyrianme Жыл бұрын
Don't EVER do front headlights. I did my Porsche Cayanne with VVivid headlight tint and it darkened and hardened and took hours to remove and now the headlights look horrible and were ruined.
@dahborj
@dahborj 5 жыл бұрын
sir.. do you use non-air egress vinyl?
@brokentougers8252
@brokentougers8252 5 жыл бұрын
What is the car?
@geeb7653
@geeb7653 5 жыл бұрын
What color wrap is that?
@Nicetints
@Nicetints 5 жыл бұрын
I didnt get that lucky it left quite a bit of glue, same material
@ripsrt6822
@ripsrt6822 5 жыл бұрын
Your car actually looks better without the dark taillight tint👍
@TecDLogic
@TecDLogic 5 жыл бұрын
Damn 4 years
@bizrankin
@bizrankin 3 жыл бұрын
I'm surprised he has so many subscribers, he never answers any of the questions in the comments.
@samseeley1853
@samseeley1853 2 жыл бұрын
Yeah, nah. We can’t see that crack on the light 🙈😂😂
@xlwraps4000
@xlwraps4000 5 жыл бұрын
Lets see that hex
@olivermusic8774
@olivermusic8774 5 жыл бұрын
Steamer.. STEAMER
@CatalinAntonescu
@CatalinAntonescu 4 жыл бұрын
I used a steamer to take mine off and it's still on there, baked on, not coming off.
5 Most Common Vinyl Wrap Mistakes
25:18
CK Wraps
Рет қаралды 3,9 МЛН
UNO!
00:18
БРУНО
Рет қаралды 4,2 МЛН
Kind Waiter's Gesture to Homeless Boy #shorts
00:32
I migliori trucchetti di Fabiosa
Рет қаралды 4,4 МЛН
Кадр сыртындағы қызықтар | Келінжан
00:16
Spot The Fake Animal For $10,000
00:40
MrBeast
Рет қаралды 211 МЛН
WARNED Not to Mix ALL 7 Carbon Pearls (So We Did It Anyway)
10:35
DipYourCar
Рет қаралды 1,2 МЛН
Hex Light TINT | Detailed & Easy Install
30:23
CK Wraps
Рет қаралды 104 М.
How to Choose the RIGHT Window Tint | Don't Make A Mistake
5:06
Chicago Auto Pros
Рет қаралды 610 М.
Tinting Tail Lights Using VHT Niteshade
19:10
H4 Torque
Рет қаралды 158 М.
How to restore headlights - 3 ways, but which is the best?
23:03
OSREN Official
Рет қаралды 1 МЛН
How To Tint Tail Lights - Film vs. Spray
8:18
Ehab Halat
Рет қаралды 2,1 МЛН
Pulling to PERFECTION! | Getting Glassed!
12:56
Dent Discount - PDR Training
Рет қаралды 6 МЛН
UNO!
00:18
БРУНО
Рет қаралды 4,2 МЛН