Tips for Electricians Bending Conduit in New Commercial

Рет қаралды 14,908

Жыл бұрын

Installing card reader pullcan and connecting in wall conduits!
Usually when bending conduit as a Journeyman we do things in a repetitive way even without measuring at times, but how do you teach a Green Apprentice who has never worked with conduit?
I tried to explain as much as I could without confusing an apprentice with table charts and equations, starting up you won't remember these things, it takes practice and understanding the basics.
Hope this Helps! ⚡️
For all my tools check out my Amazon List 👇
www.amazon.com/shop/_ksparky?...
Also shop at Wihatools.com using Code: _KSPARKY for 10% OFF ! 👇
www.wihatools.com/_ksparky
Daily content in my Instagram @_ksparky 📸
/ _ksparky

Пікірлер: 16

@Scooter2ankle 6 ай бұрын

been in the field for a couple years now and i want to appreciate the one who take the time to teach you. It was rare working with someone willing to teach you some tips or anything and when i did receive it i learned so much I cant imagine how much i would have learned in a year. Teaching has been my best way of learning and i hope if youre in this field you share some knowledge with the young ones coming in

@JuanNOnly123 Жыл бұрын

For kicks I like using the 30 degree trick. Ex. If you need a 7” kick, measure back 14” and bend it until you’re at 30 degrees like an offset and you’ll have your 7” kick saves a lot of time and you don’t have to measure it every time. For small kicks you get to a point where you can eyeball it and get it right

@blandonkennya 10 ай бұрын

That’s a good trick easy math

@gregorall9779 9 ай бұрын

When I was a much younger spark- chaser, an older journeyman I was apprenticed to had a standing rule that I only use a pencil to mark pipe and NEVER a sharpie. We all have our pets peeves.

@KSPARKY18 8 ай бұрын

Yes agree as you can see the sharpie was only use for the cut mark never for the bending spacing.