Mike your a top man!! Just sorted my transit out and it’s back on the road without shelling out 💰 can’t thank you enough. Another sub from me. Keep up the good work 👍🏻

Great video, thank you for the explanation!

Fantastic video you've got here

nice clip! thanks. I will do mine soon - Golf4 TDi. A few questions remain, is it ok to touch the nozzles with bare hands ? There are two small pins inside the nozzle point, and three holes, right, not three pins? I have a little bit of white/grey smoke from the exhaust, is that the whole injector that needs replacement or just the nozzles? thank you in advance!

Gr8 vid, easy 2 follow and nobs. I was wondering Mike, are the torque settings o these the sme for all vehicles, and if not, could you tell me what;s the torque setting for the renault master van please?

u done a greate jobe mate keep it up,,,,,,one quick qustion delphi injector what torque on nozle cap plz let me know ,,grate wall 2012 2.0

Do you need to retune ecu after installing the +30 injectors?

Have you got replacements for the 6.9 IDI Ford injectors and how to video? Thanks for the straight forward and precise video procedure

Hi.. would like to knw wat type of thr lubricants u are using??

Hello! Could you please tell me what is the tightening torque for VW 2.0 PD 16V injector cap? Thank you!!

Thank you

Could i please have the link to where i could buy the injector nozzles?

hello i have a 1.6 tdci focus 2010 109 hp i have 2 injector that have to much diesel on return line what can i do?....ohhh and my car sometimes shackes verry violently when i accelerate betwen 1900 and 2200 rpm

Good!

thank you sir..! my question is how to vary the injector nozzle angle?

How i will know which nozzle do i need?

This common rail injectors is not adjusted to its nominal opening pressure? or may I say calibrated to the correct opening pressure as per engine manual? do this injector can be fitted directly to the engine with out calibration after nozzle tip replacement? how we can ascertain that this fuel injectors opening on the correct pressure specified on the engine manual? hopefully you answers my question, thank you....

Do you stock 160% for 2.0 tdi vw bkd engine ?

Thank you for the video! I just have one question please. do the injectors need to be calibrated after the new nozzles and pins are installed? or it's exactly the way you showed us in this video and they are ready to go back in?

What’s the torque on the td5 nozzles

hi:) I have a bosch commonrail injector part № 30750283. Would you please tell me how much (Nm) tightening torque to tighten the nozzle?

Does it matter if u ran the 30+ without a tune, and heavy duty clutch

Is it always 70 Nm? I heard that some injectors like Continental shall be tighten with 50 Nm. Is it correct?

Good video..What type of oil do you use to lubricate the injectors.?

Do you normally lock the nozzle cap at 70 nm?

Thanks for the video demo, do you sell the nozzles that you have replaced and if you do sell them what will it cost me to ship it to New Zealand. thanks.

What do you mean +30?

I didn't hear it right. Is it 70Nm?

Advice : never over tighten the injectors, I once took one apart, the control valve Was discoloured from the pressure and heat, always use a torque wrench and don't go crazy on it.