Рет қаралды 304,198
Step by step how to assemble a Toyota HiLux hydraulic steering box in this video starts by installing the orings with the help of a piece of polyethylene tape, then the seal and upper bearing of the pinion are installed in their housing, then the track is placed , basket with idlers and track on the inside of the pinion, continue installing the valve with the O-rings taking into account its position (channel-pin), the safety is immediately placed, then the pinion is inserted into its housing, then the regulating cap is placed next to the bearing; once adjusted the pinion is fixed with the nut. The next step is to place the balls, for this model there are 44. Later the pressure retainer, the ring, insurance and low pressure retainer are installed. 2 small orings are placed in the casing, then the pinion is installed next to the piston considering its correct position, to install the sector shaft, the central tooth of the pinion and piston must coincide; then the cover is placed and the central bolt is adjusted. To finish the process, the steering arm is installed and adjusted taking into account the position mark.
For further explanations write to: hidraulicaveloz@gmail.com
Address: Union 528 Trujillo Peru
Visit: yovelpe.blogspot.com/