Thank you. I want to share what can help make this hobby even more enjoyable. And repairs and upgrades are all part of it. Thank you for your support!

Thank you

Thank you very much. 😊

Thank you very much 👍

Hi i am a subsriber and like and motevated to the rc world i bought the loader like yours and i do love the thing,however i lost the sound in the second week of Driving.Now i have a nother problem i got a little snow and fired up to move some snow only to find the rear weels are not engaging in only the two front weels,but the drive shaft is spinning. Now i know its not your problem I just think you might be more knowledgeable to give me some advice.Thanks.

@@RAWUSq1X4 no problem I love to help. That’s what community is about. I’d lost the sound on my dozer and it wound up being just the speaker. I found a similar size speaker on Amazon and it works great now. I would try that first to fix the sound. Now the rear axle not spinning might like be a broken gear in the hub. I have had that happen too. Lift the rear axle grab both tires and spin one. Does the other spin in the opposite direction? If not then it’s likely a broken gear. I was able to replace just the broken gear in mine and it has worked great since. Mine was in the front axle but it will be the same difference on the rear. Warning here though. I broke three bolts trying to get the hub off. I had to break out the torch and heat the bolts and hub to get them out. Let me know if you have any other questions. I’m

Thanks 😊.

I got my screw assortment from Amazon.

If it’s something like a broken gear in the hub planetary system you can just modify a pinion gear that matches to fit. That’s what I have done in the past. I got my gear off Amazon.

Hi i am in New York,where are you ?

You are correct. The higher turn or “t” number the more torque, but lower rpm per volt applied. So a 45t is lower rpm but higher torque then a 35t. So you might be stalling the motor if the torque demand (load) is too high. Check out this video of mine crawling up a steep grade with a 100+ pound load on it. It is maxed out. Any more weight and I wouldn’t have the power to move and it would stall. kzfaq.info/get/bejne/hMmWiZST0s7an6c.html

It’s tough getting angles so we can all see what’s going on and still work on it. I’ll try some different stuff. Good eyeglass camera would be awesome.

I’m not for sure. I think it may be a 55T on the original motor. It has some pretty decent torque to begin with.

This is the gear reduction unit I used. GoolRC 1/3 Planetary Gear Reduction Unit for 540 Motor RC Car Metal Gear Box a.co/d/79rs9HF

@@digitrc thank you very much

It’s better for hauling heavy, heavy loads.

What motor did you upgrade too?

I got the surpass hobby 550 80T motor and new 35kg steering servos and I can’t get it to work

@@matthewwood7103 same speed controller?

Yes I used the same one and nothing happened I even bought another one that came with that motor and still nothing

@@matthewwood7103 what battery are you using and did you verify that voltage is getting through your switch to your esc?

Thank you. And thanks for giving me your feedback too. I appreciate that.