Trail Tech Vapor Gauge Install

Рет қаралды 5,964

Dirt Bike Journeys

Күн бұрын

Trail Tech Vapor: amzn.to/452hkK1
How to make your dirt bike street legal pt.3 of 6

Пікірлер: 15

@guiltygearcore 2 ай бұрын

Nice vid sir. Does the Vapor includes the bracket or you'll have to buy it separately? Thanks

@philbowden1961 6 ай бұрын

Please don't forget to 10amp fuse red wire from battery.

@benrtd 4 ай бұрын

Instructions call for a 1 amp fuse, not 10 amp.

@Acespaceraceterrace 7 ай бұрын

My vapor keeps resetting itself is it because of the battery in the product is date out ? And can you use any normal copper wire to wrap around the spark plug where i live it’s hard to get by the spare part’s

@muriuwangai3617 9 ай бұрын

Hi, liked your content all the way from Kenya. Am looking for a good working, 2nd hansapor or Voyager unit. Any leads?

@DirtbikeJourneys 8 ай бұрын

Thanks for tuning in. Sorry no leads.

@johnsesk01 9 ай бұрын

Did you end up installing the temperature sensor? I see you have a air cooled engine

@DirtbikeJourneys 9 ай бұрын

I did not yet. Do you think it’s important?

@johnsesk01 9 ай бұрын

@@DirtbikeJourneys yes a had it on my 450x and bike would over heat every once in a while so good thing to have.

@DirtbikeJourneys 9 ай бұрын

@@johnsesk01 Ok I havent had any over heating issues but thats good to know.

@MOTOBLOGGER83 9 ай бұрын

Hello, y stall one of those, but the speed is wrong Do you know what size did u configure the weel I have the same bike

@DirtbikeJourneys 9 ай бұрын

Front tire is 21 inches

@jasonb6570 5 ай бұрын

@@DirtbikeJourneys The rim is 21 inches. The tire is bigger than that.

@DirtbikeJourneys 5 ай бұрын

@@jasonb6570 21 inches is what the front wheel is and 21 inches is the number you need to input on the vapor.

@jimellis1810 2 ай бұрын

@@DirtbikeJourneys You need to input the circumference of the front tire itself (at least that is what I have to do on my Trail Tech Endurance II meter). You can do that by marking the ground for some reference point on the tire like the valve stem. Then roll the bike straight from that marked ground point until the valve stem makes one full rotation. Mark the ground there and then measure the distance between the 2 marked ground points.