Ive bought this product and this is the BEST VIDEO IVE EVER WATCHED ON A INSTALLATION

I have this same speedometer on my pit bike and fixing to install another one on my enduro. Well made and not too expensive and works perfect. Great video 👌

Put a Trail Tech Endurance II on my KTM EXC 250 4 stroke RFS 2003 and like it. It went right in the rubber holes that the OEM speedo came out of after a tree crinkled it. Two long 4 mm bolts and 4 nuts were the hot set up with two biggish washers. Bolt, then nut then washer then nut then up through rubber holes into Endurance II on both sides. Hand tighten bolt into plastic. Snug jam nut to plastic with 7 mm open end. Wiggle down into rubber holes, than run nut up bolt to snug washer against the bottom of the rubber holes. I reset both left buttons with my right thumb while riding. This will come in handy at Dual sport "resets" on the move. I kept it down low so the old style brake line is always looping above it.

new text layer the bolt. Nice video and thank you!

Good video. Your forks are leaking

great job

Interesting seeing the installation, really thinking of getting one, does it run on an internal battery? or where does it get power from?

Taking a complete shot in the dark here but, I have a 2020 KLX300R trail bike.. Does anybody know a good speedometer / tacometer I can add to the bike ?!

Hi, am trying to acquire a used vapor speedometer online without much success. Am scared of getting a disfuntional one to kenya. I need one for my Serow xt 225. What's your take? Been following your videos

Why didn't you mount the sensor to your fork guards?

How about rpm sensor?

Bless you

How do you power the unit?

So how’s it get power ?

that bolt is a nut and the screw is the bolt

Its a nut not a bolt.