From my experience just take the back rack off and leave it off till finished. Carburetor has a hole at to that goes straight through it. Vent those to the atmosphere separately or T them together. There are 2 points that have little plastic 90 degree elbows that swivel that might leak depending on how deep you go. One is on the airbox lid. And the other is located between the airbox and carburetor. It actually attaches to the carburetor. They can pop in and out of a rubber boot. Since they swivel I wasn't too sure on how water tight they were so I popped them out and put a small amount of silicon around the end of the elbows. Do not block the holes. And pushed them back in. On the airbox lid you have to silicon the elbow and the lid at the same time and put everything back together quickly. Put lid on. Snap in place. Gas tank cover in place to hold hose in place to dry. Just my experience doing it. Thanks for the video folks. Love it

Did you buy that kit? I just want to know what type of hoses did you use. I'm currently using ABS 2 inch pipe but want to use flexible hose on my new bike.

Where do you get the vent lines for air box and belt box

Can I just buy the plate that goes on the air box separate

you said we usually do it like this a couple of time threw out the video so does that meen yall install for people too

what size tires and lift are they?

Silicone the air box shut? How do you clean or replace your air filter? Can some kind of filter go in the snorkel tubes as an alternative to the stock air filter for easy clean or replace?

I need this kit

Could you send a link to where you got this snorkle kit from?

Does the air box really need two hose’s ?

Looks like garbage