Triggertech Duty 2 stage trigger review

Рет қаралды 9,764

Жыл бұрын

Пікірлер: 25

@GallifreyanGunner 10 ай бұрын

If you had snugged up the cassette in the first place, you wouldn't have needed the anti-walk pins. Reading the installation instructions is important.

@franlkinsarmory89 11 ай бұрын

If you snug the set screws down it puts tension on the trigger pins and holds them firmly in place which you did with the other pins same thing for the other you don’t need anti walk

@ThunderClap81 10 ай бұрын

Not a bad review other than your comment on the anti walk pins. As soon as you snug down the two set screws in the cassette, it tightens up the fit of the two trigger pins in the lower. Absolutely no need for anti walk pins when using this trigger.

@keyantwilliams 5 ай бұрын

I agree

@madride858585 10 ай бұрын

You don’t need anti walk pins. Install it correctly.

@stevenhill5255 13 күн бұрын

Love how everyone shit on him about the same thing, and it's still here for me to laugh at 11 months later😂

@2amichaelj 13 күн бұрын

@@stevenhill5255 you won't be the last either

@michaelhadley5928 10 ай бұрын

You should probably read the instructions sir.

@fireyourrocketts 7 ай бұрын

Planning on getting one for my .308 built

@wood-wheel-wizard 10 ай бұрын

I use that same push safety. The trigger tech in the video is now 90$ so I bought 1.

@AKFF320 5 ай бұрын

It's 130 now, as of yesterday

@ilanmagen 2 ай бұрын

Two screws are not for adjustment, those screws name "Tighten snug-down screws" when you tight the TSDS , it locks the pins so you don't need anti walk screws. Sexy it is.

@MrPiimpslap 9 ай бұрын

Re-upload this video without the anti-walk pin comments.

@AKFF320 5 ай бұрын

Wipe the sticker adhesive off with alcohol before installing, and read the instructions first!

@PompdUpFishin 2 ай бұрын

Came here to say what’s already been said 100 times apparently 😆.

@dependablekit5500 Жыл бұрын

Use CMC trigger pins they use larger headed torx screws the Rise uses tiny little allen headed screws that round out I picked up the Rise LE 145 trigger single stage that has a 4 to 4.5lb trigger pull and has a harder hitting hammer than a lot of their others I honestly like the rise more than my Geissele due to the reset the trigger is so fast never owned a Trigger Tech but know several folks that do and they seem to like theirs hope it's a good one for you great video

@2amichaelj Жыл бұрын

I've used Hiperfire, Rise Armament, Timney, Aim Surplus, and PSA anti walk pins from their drop on triggers. They all have seemed roughly the same. It's good to know CMC has larger screws and torx heads which I think is a better screw. I'll look into them. Thanks for watching, commenting and the suggestion again brother.

@madride858585 10 ай бұрын

Is this guy serious???