Troubleshooting a 12v Landscape Light System

Рет қаралды 52,510

Күн бұрын

Here is a possible quick fix to a puzzling problem with you landscape light system. Using a Multimeter and checking the connection points could solve the issue and get your lighting going again. #aqlightitup #diy #electrical #homerepair

Пікірлер: 30

@LessThanHandy 3 жыл бұрын

A microphone setup closer to you both would have made this video 10x better.

@hammockmonk Жыл бұрын

Audio is too bad to hear.

@Oscar99929 18 күн бұрын

Thanks guys. I have a portfolio 240w transformer that I have set on "A" - automatic dusk to dawn. Recently, all of my lights connected to this transformer are on all the time 24/7. I can see the timer settings and am able to set the timer from 0-9, A, or off but the lights are still on. The only way I can shut off my lights is to unplug the unit. I suspect the external light sensor that hangs from a wire. I have it mounted on the wall as it has always been. Any ideas?

@jakemarlow8998 Жыл бұрын

Thanks for your help!

@johnnr12 2 жыл бұрын

Any thoughts on how to check the wiring to the fixtures for step lights, where the wiring is mostly underneath stone work? I have one light that flickers. Wiggling the wire doesn’t seem to impact the flicker - but other than the connection point of the fixture to the main landscape wire, I don’t know what could be the cause. I’ve already replaced the socket with no change in results.

@jessemendez9644 3 жыл бұрын

finally good video explaining

@UNDERGROUND2000 Жыл бұрын

Lol. I want to introduce you to…this guy ..as you point to ..that guy.

@nyplantings2420 Жыл бұрын

Cast Landscape Lighting brand doesn't use retrofit pods so I wonder how to test voltage. Thanks for the vid.

@karateboss Жыл бұрын

Can’t hear you

@RicardoMachin-hn4hs 10 ай бұрын

I have a light measuring 17.5 volts , how do I adjust voltage down to 12V ? Thanks

@barbender 2 жыл бұрын

You guys did great. Short and to the point. Good video. Thank you for the help.

@bmw3842 Жыл бұрын

How many 5 watt lights can I connect to a 300 watt transformer .

@rllewis 2 жыл бұрын

I followed your procedure. I have 12 volts at the socket and I have a good bulb. That bulb only glows very dim. When I put that bulb in another fixture it works fine. Thoughts?

@MacallDeaver 2 жыл бұрын

Based on your comment, you either have a bad connection at the socket or between the fixture and your home run. You’ll have to check the connection point and the socket to determine where the issue is exactly.

@rllewis 2 жыл бұрын

Thanks. This fixture is at the end of a series run. The fixture before works great and both fixtures show 12 volts. I’ll try digging up the wire from the fixture before it and see if there’s an issue. Though I don’t understand how there could be a problem if the fixture is showing 12 volts.

@simplekindofman8867 2 жыл бұрын

What setting did you have on your meter? My meter lowest AC setting is 200V. When I measure I get .8 volts. Is that 12 volts?

@youdonaldwayne 2 жыл бұрын

Tell the old guy to shut up!!!

@timpo3177 2 жыл бұрын

Arent these lights wired in parallel?

@daveinmontana77 2 жыл бұрын

Yes... they are wired in parallel.

@christiann7246 Жыл бұрын

They are! Plus if fixture 2 didn’t have power then fixture 3 shouldn’t have power either.

@nani1ization 3 жыл бұрын

The guy in the blue talks waaay to much , I wanna hear what the other is saying

@jimwaligora2354 2 жыл бұрын

Can't hear you. Get a better sound system.

@Howrad33 Жыл бұрын

Why don't you make your video from across a 1/4 acre and

@ctn830 2 жыл бұрын

terrible audio

@watercolorstone7191 10 ай бұрын

The sound is AWFUL. I stopped and went to another video because it was so frustrating.

@djcaton5139 Жыл бұрын

@bobbalouie1303 2 жыл бұрын

Thanks guys. But don’t quit your day jobs. You took over 6 minutes rambling about what should have taken a minute. Oh and get a better microphone next time.