This guy will never have dry hands, that is for sure :D

The new grease in the bucket looks so tasty

I was astonished by the fact that how much engineering is going into even a wheel

Thoroughly wash on unleaded petrol gasoline to remove grease and replace a brandnew grease... So that the spare parts will last longer... Very well explained...

Legend has it that he’s still washing his hands

I watched him disassemble it with my own two eyes and still couldn’t figure out wtf what was going. Like pieces came from nowhere, things dropped that weren’t there. Wtf😂 He’s got skills for sure

This indian guy is very hard working 🇮🇳🇮🇳

Her wife say to him „OHHHH YOU HAVE VERY GIMNASTIC FINGER” bahahhahaha

Um if its grinding its not lack of grease its bad bearings and by the sound of them you need new ones and take it to an actual shop. Plus re greasing makes no sense there was more than enough

i use Marine grease and it works great for packing hubs, planetary gears, or anything where water repulsion is a concern, as well as dirt

🤤 ahh strawberry grease love it.

Great job. Advice you to wear gloves. I had some hand skin issue due to mechanical products.

You can see everything hydraulic because of so much grease. That’s why he was having a hard time with it seating.

I can see some people's r commenting about tightening so much but here in these hubs we have something which is called sleeves and the sleeves prevent these bearing to move freely does'nt matter how much u tight it ,it will move freely just put SIM in there and tight as much as u want and keep it free also

mmmmm raspberry jelly. The old grease didn't look too bad though, I wonder why they're changing grease so soon.

Песка побольше нужно в подшипники. Говорят,дольше будут ходить... 👆🏼🤣🤣🤣

Bahut shandaar...love from HP11

Do we get in Vanilla flavour?

Good work had work

Kenapa tidak melakukan pergantian bearing? Pemakaian Grease berlebihan membuat kotoran sisa breaking semakin melekat dan menyumbat putaran bearing.. kenapa pelumasan Grease tidak di campur dengan oli agar konsentrasi atau kekentalan Grease menjadi lebih baik..

no new bearing ect? you just took the old one out and cleaned it then greased it. whats the point if your reusing the old bearing?

It didn't needed the sloppy repack, it needs new bearings and proper preload! I don't think they really understand what are they doing.

For How much time do it will last?

I see your country doing very well

Hi. May I know the size of the socket, In mm. Thanks

Good job

Is this the way to pack bearings .?

Holy preload Batman

Nice

That's one hell of a preload on them bearings. 😳

How much does it cost for one tire?

Muito bom ver o capricho desse cara

The old grease looks good to me

Wa dildar ustad ji

I hope he gets paid enough and gets satisfactory salary

imagine this guy driving a car, steering wheel always slippin' out of his hands :)

wheel bearings full of grease and dirt great for the life of the bearing...

Got to love the master techs in the comments.

👍👍👍

i bet wheels be flyin off like crazy out there

Strawberry flavor looks tasty

Dirty hands clean money 💜❤️

How much grease do I put in it??? Guy: Yes

Wow

hell the grease that was in it looked new

Das ist kein Mechaniker, sondern ein Schuster. Wenn er vor dem Demontieren der Bremstrommel die Bremsen zurückgestellt hätte, wäre die Bremstrommeln leichter heruntergegangen. Das vordere Radlager fällt in den Dreck, beim Herausschlagen des hinteren Radlagers lag dies auch im Staub. Neues Fett repariert nicht. Das alte Fett sieht noch gut aus. Ferner müssen Kegelrollenlager eingestellt werden. Das geschieht durch hauchdünnen Distanzscheiben, die bei alten Lagern dann weggenommen werden. Ferner läuft die Radnabe nach dem Anziehen mit dem Rohr viel zu schwer.

i'm a mechanic in vietnam

duble lubricant..density input.. well.. better..than watery in general so that wealthy..

Too tight are not good for bearings, I usually loosen the ties a bit and put my full trust in the safety pins, no need to use a lot of grease and no need to worry about overheating😇

Guy must be owner of grease factory.

that grease look delicius

What he did just open and close what was the issue

Relationship also want as like repair.

Ебать он туда смазки наложил конечно )))) полная ступица + в подшипники забил ))) Подшипники забиваешь смазкой, немного в ступицу и этого более чем достаточно. При таком количестве смазки как она набил - большую ее часть выкинет со ступицы в тормоза и подшипники перегреются.

There was plenty enough grease to begin with. He then cleans it and puts 10x more grease. Like he went overboard with the grease yo.

Это когда дедушка работает на гуталиновой фабрике

Pretty sure that hammer torques it to spec…

Снял подшипники,убрал старую смазку помыл, смазал, поставил обратно, смысл ? Из-за смазки выработка подшипников никуда не уйдёт)

That much grease will actually cause those bearings to carry heat and wear out prematurely. Aside from that, he's getting it done.

1:59 ляпота😂

The bearing might be worth more then the mans time and grease, So they are overly Maintenace the bearing. To make it last longer. I'm just trying to understand

Why do they use grease? Here in the states we use oil in everything that I've ran into. Just seems more likely to have a bearing burn up.

Excellent💯👍👏

Ongoing use of horns….would drive me crazy

I don’t understand why they are doing it in the first place. The colour of the used grease tells me that it was not even driven 1000km. I can say that because the quality of grease used in our countries is so bad that it would turn black after 100km. The only thing I can think of is that the previous job didn’t solve the problem and neither would this. It needs new bearings.

Timestamp for gunk action plx

जितनी देर में ड्रम बार निकालते हो ना इतनी देर में हम फिट कर देते हैं

Luman is also best Grease

😊😊😊😊😊

right issue , wrong solution 😅

❤❤❤❤❤🎉🎉

Its already lubricated

Needs more grease!

Sir hum bhi kaam karte hai truck ka btao jarurat ho to

Pensei que estava fazendo suco ou algo do tipo 😃

All that work and he left the worn out brake shoes on.

Forbidden strawberry flavour grease

Greasy

ميكانيك احبه

Велосипед я так в детстве ремонтировал......подшипники и гайки в песке качал,в бензине патом мыл ,всю эту хуйню обратно ставилно солидол ,за то новый......

id end up dropping every part on the dirt..

В Пакистане смазка только красного цвета? 😊

muito pouca graxa , precisa de mais graxa hahahahaha

Boss...Guy come on iv got half day job 4u in Mc Donalds..come fast. Guy....Just a couple of mins boss ill be there in ten.

That kerosine oil ruined the grease..cause mechanic didn't dry it or clean it properly....lol.

Feel bad for his hand

4:07 “Arre maa ….. …. h, bataye re ho!” 😂🤣

Какой смысл проделанной работы!??

The thing is this vedio and truck man both are from India and there's not even a single comment by an Indian And all the way the title of the vedio is in russian.. 🤣😅🤣 so much confusion

MYTHS ABOUT HYDRAULIC OILS My Self Yash Bhatt, Chemical & Lubricant Engineer (Lukeron Lubricants India). I want to tell you so many things as per your video. MYTH About Hydraulic Oils 1. As you say the Yellow oil is having a Dust particles and other contamination so you are wrong in this. The Yellow oil means This Oil Having wide range of Additives such as ZDDP, AW, MPS. Yellow color doesn't means it's a bad quality. 2. As you say that about viscosity right. In The White Tube Oil is Hydraulic HLP ISO 32/46 and In a Yellow Tube Oil Viscosity is a ISO 68. That's why there is difference in flow rate. 3. Viscosity depends on application and NAS value. Please do not claim wrong information, first you go and analysis. 1. Base Oil Types : Naphthenic & Paraffinic 2. Base Oil Groups : Group 1 - SN70, SN150, SN300, SN400, SN500, SN600 (Viscosity Index range - 95 to 105) (Appearance - Yellowish) 3. Group 2 - N70, N150, N300, N400, N500, N600 (Viscosity Index Range - 110 to 135) (Appearance - Bright & Clear) 4. Group 3 - cSt 2, cSt 3,4,6,8.

I'm from Việt Nam

There was enough grease already.

Better work than most ASE certified techs

is that bearing realy need that much of grease?? Kind too much for me..😅

Forbidden tomato paste

not enough grease :D

itni sari grease laga di hai aur sala chalte chalte truck ruke hi na :D

Pls use gloves

i think it needs more grease

Перегретый подшипник нельзя повторно использовать.