Very Helpful I am making Plans to Return to Work after a 4 year battle with Cancer.I still have My 2003 Columbia and These Videos show how simple it is to do the work with the Proper tools.Thank You

What a nice calm guy and what a great video... 😊 thank you so much

I like how you treated that fitting. Excellent tips

Great video Starkey trucking I am a new subcriber learning a lot planning to be a CDL holder soon and become a diesel technician already have 9 years of experience my dad taught me what I know so far this video was helpful in my quest to be a diesel technician thanks and God bless and blessed 2020

Thank you for the homemade knowledge I appreciate it, Robert from Florida👌

Nice work. Thanks. Pete. Australia

It's best to use liquid teflon. Tape strands can come off and enter your air system as well.

You definitely did help me to save some money👍 great video! Thank you👍

Thank you for sharing your knowledge.

Great video sir Thanks so much

Good job fellow trucker.👍

Good Video well explained God Bless you

GREAT JOB 👍 BUDDY

Well explained thanks 👍

It's a lot easier to use the air suspension to replace the Jack's. Just cap the air line.

Thanks for the help useful video

Tighten the top of bag first could get a slight twist in bag going the other way.

GReat video thanks

Don't need jacks just cap air line you removed. Start truck, pump up other air bags remove and replace.

Thanks man god bless

AWESOME.... Thank you So Much.....🙏

Doing it the hard way

You can preventable rebuild the air albow fitting with new o ring inside where you push it in.

I had a person ask me why my airbags air up higher then normal, there is a good reason why . I adjusted them to be a little higher due to hauling heavy permit loads , but in this video they look a lot higher due to I am not on flat ground . Before I adjusted the air bags back in 2008 the truck looked like it was sagging in the rear when I hauled heavy coils , so I simply adjusted them up . And no I have had no problems from this though the years , and I drive cross country to about any state. Every truck I have seen can be adjusted.

I changed an airbag a couple months ago , this morning I saw the plate or part at the bottom of airbag was missing, any idea why, may be the nut at the bottom became off and that caused it

I do exactly the same way you do.

کیسه هوا کج بسته شد،،به علت کج بودن فنر اصلی محور

Suggestion: use mentioned that you used WD-40. That is a poor product to deal with rust. Best practice is to use a product labeled "penetrant". It works better and faster with the primary purpose of counteracting corrosion. WD-40 does not do that. Apply it as early as you can in your process to allow it to do as much work as possible.

I noticed on the door of the truck it said Thurman, OH. I only live about an hour from there, outside of Pomeroy

Larold, Delta, Ohio

Push your air line in farther ,look at the black paint on the airline

Hey fella, when I try to lose the bottom bolt on my air bag, the rubber bag and bolt turns. Any ideals to remove the bad air bag? Thanks...

Why is right one crooked?

Man you probably installed wrong airbag. It is strangely un-parallel. I would reccomend you to use ordinary wrench or better torqe wrench especially on upper bead plate. On upper side is usually 30-40Nm (Torqes are on sticker) When installing you can use external air supply just enough to lift it

why do you have an airbag crooked on your truck?It is not right

Jack stand? Huh Air plug or cap and life is easy

That’s a lot of work changing a air when u don’t really know what u are doing

Hey great video sir‼️🫡🫱🏼‍🫲🏽do you have the actual number?? i believe we have the same model