Tuning a 2022 Kawasaki Z900RS

Рет қаралды 1,865

11 ай бұрын

2022 Kawasaki Z900RS has been de-catted and is otherwise stock. Got the results of the gains made from stock to de-catted, and now tuned as well.
*****************************************
Save money on Brock's Performance Parts by clicking brocksperformance.com/?aff=80 and entering code TeamWrighteous5
To schedule your bike to get dyno tuned or have the ECU flashed, contact us through one of the social media sites below...
57 MOTORSPORTS LLP on Facebook
Follow me on...
Instagram @TEAMWRIGHTEOUS
TikTok @TEAMWRIGHTEOUS
And / chad.wright.. .
Check out Logan's channel for more detailed videos @Ringr57
Check out our website for more information... Still under construction... WWW.TEAMWRIGHTEOUS.COM
#TeamWrighteous #57MotorSports #gsxr1000 #suzuki #ZukeNation #GSXR #KAWASAKI #Ninja #ZX10R #ZX14R

Пікірлер: 15

@QuinnBoone 10 ай бұрын

Stoked! You guys did an awesome job! Thanks again my friend!

@TEAMWRIGHTEOUS 10 ай бұрын

Man, I'm glad you're enjoying it. It definitely needed this.

@chriatiansandy6233 10 ай бұрын

That is one good looking motorcycle I like that

@TEAMWRIGHTEOUS 10 ай бұрын

Yessir... It's a great looking bike. It rides so good too.

@carlatamanczyk3891 6 ай бұрын

After those mods how does the motor pull at low rpm roll on? Narrow up the low end torque a little bit ?

@QuinnBoone Ай бұрын

It picked it up from 2000 rpm out to close to redline....

@Gabriel-lb8or 8 ай бұрын

Hi everyone, I'm writing from Italy, Thanks for your helpful videos. I have a question for you, I own a z900rs se version 2023, I would like to put the link pipe as in the video and remove the breadbox, I have seen in many videos that this bike has 2 CATs, one inside the box and one in the tube after the o2 sensor , did you leave this? I would like not to remove everything for fear of too much noise. Thanks 👋

@TEAMWRIGHTEOUS 8 ай бұрын

It was all removed. Gutted the pipe, and cut off the bread box. It wasn't very loud at all. It still has the stock muffler on it. It's very nice sounding.

@aashishpatel3969 Ай бұрын

i did the cat + breadbox delete on my z900rs cafe 2021, there is only one cat on this bike and that is located in the short section just before the breadbox. the breadbox is basically the muffler and resonator which gives the bike that nice purr. if you pause the video near the start when he shows you the exhaust you can see a color difference where the original exhaust is and where the cat/breadbox delete starts.

@mattriley1426 7 ай бұрын

How do you do the de cat? I have a 23 900 cafe and had a tune done by Ivan. Bone stock with a tune. Looking to remove the cat in the most economical way possible, and then im done. What would be your advice?thanks!

@toddsheppard9899 Ай бұрын

The easiest way I think is to just replace the headers with a catless system, while keeping stock can.

@lautarocuttica9581 Ай бұрын

how do you like ivans tune? worth it?

@mattriley1426 Ай бұрын

@@lautarocuttica9581 yes its perfect

@daveh9003 2 ай бұрын

Hi, mighty good video, very interesting info, thanks. Writing from England, have same bike & want to do this. Question if I may, did you disable the Secondary Air Injection prior to flashing ecu? I'm told you have to or the injection of fresh air from the air box to the exhaust pipe will mess up the readings taken by the probe you put in the exhaust to measure? Others say it doesn't matter. I'd love your input seeing as you've done this dyno ecu flash. Cheers!

@TEAMWRIGHTEOUS 2 ай бұрын

I never worried about it... It didn't affect the tune at wide open throttle. And regardless of what the graph says, I tuned them based off of what made power. But when you have someone else tuning your bike, just do what they want. It makes it easier for them... All you need is a marble inside the hose that goes to the airbox.