I've probably watched a dozen videos on this drill press. You're the 1st one with enough sense to raise the table out of the way before running in the bolts from the column to the base.
@icandothat9052 ай бұрын
I’m sure I’ll do something stupid later to make up for it 😅
@sebumgold31088 ай бұрын
I have owned this unit since 2017, using it several times a week and it is solid.
@icandothat9058 ай бұрын
So far I’m very impressed with it.
@sebumgold31088 ай бұрын
@@icandothat905 I like things to run silent. A 3/8 rubber matt under the base has cut the sound by 75%>
@wheflin16168 ай бұрын
On the depth gauge on the left, are you able to unscrew the top most nut in order to get slightly further travel than 3 1/8"?
@icandothat9058 ай бұрын
Yes the top nuts will come completely off but the full travel is 3 1/8 regardless
@wheflin16168 ай бұрын
@@icandothat905 Gotcha, thank you!
@mmoncur10 ай бұрын
Thanks for the video! If you get a minute can you tell me the dimensions of the base and the top part, and the height of the whole thing? I'm hoping to purchase one and figuring out if it will fit on my workbench.
@icandothat90510 ай бұрын
Sorry, missed this comment - the base is 16" x 9.75", overall height is 37" and the overall depth is about 22" (had to eyeball it) from the back of the motor to the table (not extended).
@mmoncur10 ай бұрын
@@icandothat905 That helps a lot, thank you! Man that thing is tall, I'll have to make room!
@icandothat90510 ай бұрын
Ha, yeah it is, but you get a lot of clearance with it. Good Luck!