Upgrading to the Zenith 650 Nose Gear Suspension
Рет қаралды 1,915
Күн бұрын
@joseruiz-Joecool 2 жыл бұрын
Glad to see your on the way to finish this 601 😀.
@michaelbevan3285 2 жыл бұрын
replace that gascolator. It's useless. Fit a better aftermarket gascolator and drain. Also, if you haven't already, cut out and install a hatch and door under the belly for access to the control cables. It makes life so much easier when it comes to rigging. After that, reinforces the centre section in the cockpit which acts as a map pocket/storage bin. It is originally made from very light alloy and is too flimsy by half! You should fit an Andair fuel selector as the original is not good. Also, reinforce the instrument panel as it is too flimsy and will warp.
@zenvairpilot 2 жыл бұрын
a lot of that is in the plans.
@semidemi339 Жыл бұрын
Does Zenith make a system like the front one you just installed for the main gear?
@zenvairpilot Жыл бұрын
sadly no. the newer design ises spring gear
@justbuildit1703 8 ай бұрын
Curious how much this mod costs, as im picking up a 601 in a couple weeks and dont like the bungee set up, thanks in advance
@zenvairpilot 8 ай бұрын
I had to modify the firewall with all of the 650 parts. then pick up the puck system. Weld the bungee pin hole closed. then install. it was around 800 for everything. if you have a 601xl then you only need the puck system and to weld the hole shut. total for that about 500.
@justbuildit1703 8 ай бұрын
@@zenvairpilot Thanks for the info, it's a 601xl so good to know it's a bit cheaper!!
Zenith Aircraft Company
Рет қаралды 11 М.
Garage Fab
Рет қаралды 207 М.
Aeroworks Productions
Рет қаралды 3,7 М.
Robinson Foundry
Рет қаралды 3,4 МЛН
Ivan Ivanov
Рет қаралды 5 МЛН