Рет қаралды 2,328
I made a new Pennyplane variable pitch prop hub recently and videoed each step, I tried to be concise but holy cow there were a lot of steps! So I split the video into two parts. Part 1 shows making the prop shaft, the driver bar, and the t-tube setup, Part 2 shows the screw holder, prop holders, and spring.
Here's where to get the stuff mentioned in the video:
www.cstsales.com - carbon fiber tubes and strip, and (in Part 2)
Rohacell 71 IG foam and unidirectional carbon fiber.
www.microfasteners.com/ - 00-90 nylon screws, 00-90 plug tap