Verification Jig Fabrication, Pouring a Multi implant Impression, Custom Tray

Рет қаралды 40,143

5 жыл бұрын

This video demonstrates how to fabricate a verification jig, custom tray, and how to pour a multi-implant PVS impression.

Пікірлер: 15

@Dr.Vinnie 2 жыл бұрын

Lovely! Thanks ❤️

@BoiseProsthodonticsChannel 2 жыл бұрын

You’re welcome 😊

@gcmillar 3 жыл бұрын

Good video. I had trouble hearing the audio though.

@BoiseProsthodonticsChannel 3 жыл бұрын

gcmillar sorry about that

@safwanfallaha7311 3 жыл бұрын

Very nice and clean. What was the transbirnt material you used on top of the imprission stop??

@BoiseProsthodonticsChannel 3 жыл бұрын

Wax

@gianmunoz4669 2 жыл бұрын

Que es lo que inyectó al final

@gianmunoz4669 2 жыл бұрын

Que tipo de material es el transparente ,

@BoiseProsthodonticsChannel 2 жыл бұрын

This video we used Triad Gel. I believe they discontinued the material. We now use Primotech material

@gianmunoz4669 2 жыл бұрын

Pueden subtitular please

@user-mt7cn3ci7x Жыл бұрын

Nice work But i did not understand why there is no isolation before putting light pink

@BoiseProsthodonticsChannel Жыл бұрын

Not sure what you're asking.

@FL-gg4dq Жыл бұрын

Sorry I'm confused. Why do you need a verification jig. Can't you just polymerization the resin between copings intraorally then you don't need verification

@BoiseProsthodonticsChannel Жыл бұрын

That doesn't work. The acrylic shrinks overtime and thus it cannot act like a verification jig any longer as it will not longer be accurate.

@FL-gg4dq Жыл бұрын

@@BoiseProsthodonticsChannel thanks for answering. So all this is to reduce the shrinkage? . Does composite/ flowable shrink that much ? plus wouldnt the heavy body tend to keep the open tray copings in place quite well already?