Best video ever. Thank you very much. I've recently bought a Volvo and man that's a joke car. I will try to fix this issue soon. Thanks again for your tutorial.

exactly same fault as shown! thanks saved £100 exchange! cheers.

Well done...seems we all have the SRS message, and need the soldering job to be done...04 xc 70....My clock takes off and does a 24 hour lap for a few minutes....and the gas cap sends a message that clears...tighten it down, it re sets, recent gas fill or not.....re tighten, it goes away...but SRS...that remains....The way to re solder is delicate, but the 2 little chips area was revealing....great video

You're a star mine had exactly the same problem. Re solldered those two chips and it works as new. Thankyou for putting this out

Subscribed based on this one video, super helpful with all the details needed

Thanks a lot, i had the same problem and i fix it with your help. :)

great gonna take mine out tommorow!

We have repaired thousands of these DIMs. After this video aired, we have been getting these DIMs in our shop looking like this guys DIM. Please don't heat up the processors directly over the coating like that. We get them in with the microprocessor pins dragged to the sides, broken and/or shorted which in most cases fries the processor. In these cases an expensive processor replacement is in order. This guy got lucky but I guarantee you it will fail soon with soldering like that. It takes precise technique and skill to solder microprocessors, not to mention the correct equipment, heat setting, solder, flux, etc. Please just send it to the pros.

I have done this job many times...you need to solder all the connections under a microscope...and also test some of the components...some resistors are prone to go bad on theese boards

do you have any experience with 2004 Volvo XC70 after passenger dash airbag deployment? If I replace the airbag/dash, impact sensor and SRS Control module from a junk yard car do I still need car reprogrammed? Car won't start, Airbag fault message on dash.

Thanks for sharing. the DIM of my 04' S60R , sometimes it lose the electric power suddenly , and then resume , it comes up SRS/brake warning , 1. is this same case that you figure out in the video?

Thank you

Do you have the link to buy the diagnos tool?

Is it possible to change the place of the 2004 model volvo s60 display table and the top models with the 2013 or 2015 s60 table? Does it fit or what might be required for them. Can the problem be solved with extras such as software, program installation or extra electrical installation, thanks in advance.

hi also the reason is only with the high beam indicator it doesn’t light up can you tell me what is responsible for this light bulb

So initially/before the re-soldering the SRS fault could not be read or could not be deleted?

If you feel like having a go at reworking the solder joints around the larger chips watch: kzfaq.info/get/bejne/e7OggbueurrZh58.html

i send my cluster for that it came back srs message still coast me $260

Everybody clears the code but that doesn’t really fix the problem.