The following video explains the procedure to carry out an engine oil and filter change on a 2011 Volvo XC60 D3. Engine type code: D5204T3
The procedure should also be the similar on most Volvo 5 cylinder engined cars. The procedure should be the same or similar on 2008 - 2016 models.
The tools, parts and steps to help you carry out this task are also listed below. And if you have any questions please let me know in the comments.
Please subscribe for more content. 👍 And please click the like button.
------------------
🛠 PARTS USED IN THIS VIDEO 🛠
If you require a service kit for your vehicle I purchased mine from this site: ebay.us/xVKW5Y
The specific service kit I use for the vehicle in the video can be purchased from the following link: ebay.us/3tbc1K
This is an affiliate link so I will receive a small commission at No extra cost to you.
------------------
Chapters:
0:00 - Introduction
1:05 - Removing undertray
1:40 - Draining the engine oil
2:25 - Removing the oil filter housing and renewing the filter
4:45 - Refitting the oil filter housing
5:10 - Fitting the new sump drain plug
5:55 - Filling the engine with new oil
6:30 - Starting the engine and checking for leaks and level
------------------
Tools and parts required:
1 - T30 Torx or 12mm socket for the sump gaurd
2 - 36mm socket for oil filter housing - 17mm socket for sump drain plug
4 -Torque wrench
5 - Container large enough to hold all the old oil
6 - New oil filter
7 - 5.9 litres of oil (Check the recomendation for your model - engine - country)8 - Oil drain plug washer
9 - Means to raise the vehicle safely to allow access. ie Ramps - Jack - Axle stands
------------------
Procedure:
1. Run the engine until at normal operating temperature.
2. Raise the front of the car. Be sure that it is secure.
3. Remove the engine under tray (T30 torx drive). These may be different on some vehicles.
4. Position a container under the engine alligned with the oil drain plug.
5. Remove the oil drain plug (17mm socket) and drain the engine oil (the oil will be HOT)
6. While oil is draining, use a 36mm socket and remove the oil filter housing.
7. Remove the old oil filter, clean the housing and replace the o-ring.Lubricating the new O-ring with oil. Fit the new filter and reinstall the housing (Tighten to 25nm).
8. Reinstall the oil drain (with a new one if supplied) and tighten it to 35 Nm. Always use a new sealing washer.
9. Fill the engine with the new oil specified for your vehicle. (The oil for this particular vehicle is: SAE OW-20 Fully synthetic and the make of oil is Mannol Legend Ultra) (Please see the above links to purchase this oil and service kit) Check the level on the dipstick or electronic display and top up to the required level.
10. Start the engine and check for oil leaks around the oil filter housing and the oil drain plug. When on level ground re-check the oil level and top up if needed, but do not overfill.
11. Reinstall the under tray.
------------------
Thanks again for watching and I hope you found this video useful.
#Oilchange #Volvo #DIY