VW T25/T3 rust repairs - mild restoration part 2

No video

VW T25/T3 rust repairs - mild restoration part 2

Рет қаралды 10,182

Күн бұрын

Garath gets stuck into the welding repairs on his T25 / T3 volkswagen camper.
Visit www.themx5resto... if you have an MX5 that needs anything from servicing to a full restoration
Visit www.adrianflux.... for an insurance quote on your MX5
Follow the channel on Facebook / lightsuplightsdown
Follow The MX5 Restorer on Facebook / the-mx5-restorer-12395...
Disclaimer - All works and procedures shown in any of our videos are carried out by fully skilled and trained personnel and are created for entertainment purposes only, anyone watching and wanting to replicated anything shown in our videos should be correctly skilled and qualified to do so, and is responsible for their own actions, The MX5 Restorer and Lights up Lights down do not accept any responsibility for any injuries, or damage caused to vehicles or property by any persons attempting to replicate anything shown in any of our videos

Пікірлер: 8

@Muftobration 7 ай бұрын

Thank you for showing your process here. My van has terrible rust in that exact same rear right jack point. I'm in the US, so that's my passenger side with the slider. The lower corners of the slider opening are rotten on both sides (front and back). I'm looking for references and yours is the best I found so far.

@TheNorthernmunky 2 жыл бұрын

Brilliant, always a pleasure to watch and learn

@wackedoutdude 2 жыл бұрын

That's a pretty clean van. Usually the inner sill and floor is an horror story. You've caught it early. Quality work and great content.

@Dave-on3cx 2 жыл бұрын

Any more mx5 workshop vids.?

@alstirling69 2 жыл бұрын

Whats going on in the garage..?? Is everything ok..? We've not had any good MX5 repair or updates in months.. Hope you're all ok..? Al 😎👍😳😳

@blastosist Жыл бұрын

how do you recommend removing a paned along a seam? I need to replace my rear quarter like you have done here but want to preserve the flange of the adjoining piece thanks

@lightsuplightsdown3018 Жыл бұрын

Its usually a case of drilling out the spot welds and then grinding back until it comes away