wasting time on a unimat lathe
Рет қаралды 4,877
3 жыл бұрынsometimes, after work, you have to try really hard to come up with a reason to go in the garage and use the tiny lathe: I need this thing. For this song. It'll only take me a minute. I'll clean up after. You can't buy one. Nobody sells them, there's no profit in it. You have to make them.
@brianpeers 10 ай бұрын
Thanks for sharing. I found it enjoyable and inspiring to keep making stuff with my SL1000
@VintageGearMan Жыл бұрын
Where did you get that nice 4 jaw chuck with the allen wrench set up? Does it have the same capacity as the standard Unimat 3 jaw chuck?
@MegaSupyo Жыл бұрын
If you have the same large as me, I believe you need an M12 thread chuck. I got mine on eBay, new from India. The real unimat ones are available but cost twice as much. I'm happy with mine but results may vary witth these things. www.ebay.com/itm/154870792670?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=jaqccrfssea&sssrc=2349624&ssuid=1QFV6tUSTua&var=&widget_ver=artemis&media=COPY
ISSEI / いっせい
Рет қаралды 93 МЛН
AnythingAlexia
Рет қаралды 24 МЛН
Anthony Shelton
Рет қаралды 39 М.
Rany Homemade
Рет қаралды 82 М.
Adventures with a Very Small Lathe
Рет қаралды 40 М.
ГОСТ ENTERTAINMENT
Рет қаралды 902 М.