When you used your hand to brush off the ragged burs from the spot weld holes , it made me flinch.

Perfect timing, getting ready to do this on my 1967 Firebird 400.

For some of the misalignment you could try an old pipe fitters trick. I don't know if there's a proper name for it but its apiece of flat stock with a v-notch cut in one end that looks like a fishtail. Weld one side of the tail to one side of the gap and use the handle to pry across the gap to get alignment.

I love the clean and strip wheels instead of the wires wheels. I feel like they do a better job and are a bit safer. Either way, stay safe and have fun.

Jeff - Hope you and the family all have a very Merry Christmas. Thanks for all you do.

Nice job. Thanks for sharing the process. Take care, Ed.

Good job, great work, love the old Ford!

I think your doing a great job looking good 👍

Making the best out of a rough situation And I know you know how to tweak out the rough spots! Good job, Jeff! 🏁

Thanks!

Floors and rockers are next on my 62 C10 project, making it mandatory to watch every repair panel video available on YT!

That's a lot of work! Way to stick to it.👍

Do u have a video on setting up the mig welder to do the floor pan with a cheap harbor freight welder?

Hey Jeff I'll do ya two better on your next floor patch give "Steel-It" a try it's a poly weld through paint that your kids will love welding with it applied, an when done finish with "fluid film", you'll never worry about rust again, I gt both on the tropical river web site. Both are worth Their weight in gold.

1st on your you tube channel and 1st in my heart ❤️

Do you recommend gaps or no gaps when welding floor panels

So your pan is cut exact to the hole in the floor you make or is there any overlap?

So my main question is, how are you keeping from setting the underside of the car on fire? Serious question as I have had it happen while doing other repairs, like exhaust work for example..

Always a tradeoff on the rust prevension

is it better to overlap the old metal and seam weld to it or is it better to cut and but?. I am about to weld some new pans into my 70 fastback. Is cut and but strong enough?

"Electric Glue Gun"

Learning to weld a floor pan For my 87 camaro because i dont want no starngers fingers in my ol girl. Lol

😃👍

Good old 18v dewalt.

i am going to get a 1976 ford thunderbird

Is this complete? Tac welds are just the start, right? I'm not a welder, just trying to understand.

Ear plugs wouldn't be a terrible idea.

Every tool is a hammer unless it’s a screwdriver then it’s a chisel 😅

You have made this job a lot harder than it needs to be first you should of used a strip an clean disk then used the cut and but method to put your panel in.