I was checking this out too. Unfortunately for the convertible the whole back panel is one piece with the cubby and has to come out along with the roll hoops to get access. Remove the lower black plastic trim piece that sits just inside the weatherstrip held by clips . This comes out along with the plastic trim that connects to it and runs up to which the seat belt runs through. pull away .. Repeat for both sides. Next prize both speaker covers they have plastic tangs. Start at the top. the bottom of them has lips on one side so yo have to remove top and side clips then twist it out. that gives you access to the 4 each bolts that hold the roll hoops in. Remove them. The roll hoops lift out but have built in 2 clips each at the rear bottom that hold them into the rear big trim panel. remove two plastic push pins that sit inside the storage cubby. then the whole rear which will lift out. It has several panel clips under its upper horizontal rear face. If I could post the photos from the workshop manual were it would have saved me a lot of typing.

How do you go about doing that?

@@Dark1Masta It literally goes over it in the video. 1:05

@@xsevo1028 thanks

You can tell just by looking at your screen....the layouts of the two are very different.

If you have the big gray plug at the back of your DVD player in your console you have a bosch.

It's the same as this video...I have had my screen out in my 2016 convertible....it comes out the same way as this video.

You are looking at it....nothing different....