Wiring An In Cab Winch Switch On My Jeep TJ

Рет қаралды 5,098

2 жыл бұрын

In this video I wire in an in cab winch control switch into my Jeep TJ. You can do this with almost any winch and it is a great tool to use instead of having to use that long controller that's always tangled. Don't forget to check out my instagram, also I now have a P.O. Box listed below. Thanks For Watching.
Winch In Out Switch: amzn.to/33WryB4
Bomber Switch: amzn.to/3tOrazl
Vent Switch Panel: amzn.to/3qS4ZX4
P.O. Box 801
Mojave CA 93502
Follow me on Instagram : itsprojectventure
Please e-mail itsprojectventure@gmail.com for all business inquiries.
DISCLAIMER:
This video is intended for entertainment purposes only. The creators of this content and any affiliates are not liable or responsible for any property damage or injury as a result of any information contained in this video. Some links above are affiliate links which there may or may not be a small commission on the use of these links.

Пікірлер: 14

@danhambrick6331 2 жыл бұрын

Nice job.👍👍

@ProjectVenture 2 жыл бұрын

Thanks.

@brbadventurer Жыл бұрын

2:11 Is that hardware store 3/8" fiber core rope spooled on your winch? 5:19 Those rocker switches have a back light that you could wire into your instrument panel lights or park lights so it lights up when your lights are on.

@ProjectVenture Жыл бұрын

The winch rope is from Olympus Off-road. Unfortunately their business did not survive Covid.

@squishylithium 2 жыл бұрын

Great video. What size wires did you use?

@ProjectVenture 2 жыл бұрын

I used 14g for all the wiring.

@bewarebagels8410 6 ай бұрын

I know this video is a bit old, but is it necessary to have the power switch to the winch switch or is that a safety precaution? Where I am mounting it, I am not worried someone will bump it.

@ProjectVenture 6 ай бұрын

It’s mostly as a safety.

@jaredhb7706 Жыл бұрын

What gauge wire do the smittybilt winches need?

@ProjectVenture Жыл бұрын

For the power wire for the winch I would go no less than a 2g wire. If you are running an in cab switch with additional relays I would use 14g from the relays to the winch solenoid and 16-20 from switch to relay. If not using an additional relay I would run 14 right to the switch as long as the switch can handle the load.

@thomasmercer4266 17 сағат бұрын

Can you still use the remote?

@ProjectVenture 17 сағат бұрын

@@thomasmercer4266 yes. The remote still works normally.

@deanlarkins5858 Жыл бұрын

I did not like the video. I wanted to see how you wired up the momentary toggle. You didn't show that it was already done and you just showed us the obvious stuff.

@ProjectVenture Жыл бұрын

Thank you for your feedback. I will keep this in mind for a future video. I will be doing another switch in the near future and I will try to include more information.