doing the wj knuckle swap on my zj. iv got almost all the parts necessary but need to get it apart for mock up to see what else I may need to order. how to put wj knuckles on zj or xj or tj
Пікірлер: 11
@227lazer Жыл бұрын
Thanks for saying why the spacers is important
@227lazer Жыл бұрын
Good hot Tack weld joints in. Let cool between welds so you dont melt the joint. I did that to mine it's the best way to do it even if they do fit tight
@xjbeater86383 жыл бұрын
I wheel the hell out mine. Trust me when I say weld a bead on them ball joints. And each end cap on your axle shafts.
@clintonbeason16383 жыл бұрын
Nice more zj videos we need more zj diy on the KZfaq
@thomasbeyer3 жыл бұрын
Will do. Thank you
@motownXJdad95653 жыл бұрын
on your ball joint press, if you use red bearing grease on the acme thread it will work better and last alot longer. after i installed my new ball joints, i used the same press for the upper control arm bushings😁
@thomasbeyer3 жыл бұрын
It's a rental lol but yes that would make it easier I usually use arp bolt lube on my things
@motownXJdad95653 жыл бұрын
@@thomasbeyer ah i see, theyre dirt cheap on ebay and amazon so i figured it was yours lol
@thomasbeyer3 жыл бұрын
I'll get a good one soon iv always worked somewhere that I could borrow one so it was never a problem before. Definitely want a better kit than this one.
@jimmyras803 жыл бұрын
What did you use for a cheap shock extender?
@thomasbeyer3 жыл бұрын
Watch zj on 33s with 3 inch lift for more details. But if I remember right i used some 3/8 all thread joiner pieces from the local tractor supply