In this video I set up and use the powder measure, but it is way too slow.
Пікірлер: 10
@andy79z282 жыл бұрын
You should do a regular powder drop to fill up the feed tube before you run the powder cal like 15 grns. If you do not the machine will not do the powder cal correctly. Run the powder cal again after the feed tube is full. Then you will see the speed difference. Hope this helps.
@j.sagiechode2 жыл бұрын
I have had two of these.. you did not complete the powder CAL correctly.. it goes wayyyyy faster than that, when you get the power CAL correct.
@Blak_Da_Gunsmyth2 жыл бұрын
You beat me to it. Brother, you may have a bad unit (it happens), but you did not complete the powder cal at all. This thing puts out powder at an incredible speed. It only slows down at the very tail end of powder disbursement.
@Dwayne78342 жыл бұрын
Thanks for the video. I don’t know much about the electronic scales such as this one.
@Blak_Da_Gunsmyth2 жыл бұрын
I WOULD NOT TRUST THOSE LOADS!! The powder calibration is incomplete, regardless of what powder you use. Please, recalibrate powder and let it finish.
@3142992 жыл бұрын
My Lyman "Gen 6" dispenser works a lot quicker, but I generally restrict it's use to stick rifle powders.
@charleslayton453 Жыл бұрын
It was slow because you didn't do a proper powder cal. See previous post.
@seankaminski36482 жыл бұрын
My rcbs u can adjust the speed agree that is slow as heck
@jamespollard16702 жыл бұрын
Too slow for my taste .
@gunsnwater26682 жыл бұрын
Has to be a way to speed that up. Otherwise it’s useless.