This was so helpful! Thank you so much. I've been trying to create an H-bridge using transistors but I kept running into overheating issues with them so this was super helpful!
@MarcdeVinck4 жыл бұрын
Glad it helped! Even a dedicated IC can overheat, so make sure you have cooling if needed. And always check the datatsheets!
@anthonytesta37165 ай бұрын
So the slip ring need a motor to turn the output end?
@kuchalaggyan25023 жыл бұрын
Sir, can you make a video related to motor deriver and their variant. Because I have motor’s ratings are 12V 10A, which motor driver would you use?
@MarcdeVinck3 жыл бұрын
10A is a lot. I would use a motor driver breakout board. There are dozens available online.
@kuchalaggyan25023 жыл бұрын
@@MarcdeVinck Yes, you are right. But I am confused which one is the best from all this.