XMaxx upgrade your spur and pinion gear from wobbling and destroying itself.
Рет қаралды 968
3 ай бұрынA must do to your xmaxx. . It will be your best investment on your XMaxx from tearing up your pinion and spur gears. Maybe you don't have to go 1.5 mod gears. Also upgrade your 7726 tie bar. I see they make them in SS.
(GPM Upgraded medium carbon steel cush drive input shaft and aluminum 7075-T6 bearing mount)
(Traxxas Part #7786X)
@jagergerg9771 Ай бұрын
I did the same thing with my heat sink. Running the same set up as you are,
@readeracingRC Ай бұрын
oh really. it is the original heatsink wedge and pried and taped onto get it under the top rail bar? i thought i was original. lol you have the 1100kv hobbywing?
@jagergerg9771 Ай бұрын
@@readeracingRC Indeed I do, I pried it open a bit so it covers the motor. I also shaved the sides down a bit so I could get it over the top rail bar, then used two zip ties to the motor. I also have the stock fan housing, I replaced the stock fans with Rocket Fans, they fit in perfectly.
@daysdesigns 3 ай бұрын
And another tip is to run a couple of the bolts holding that plastic cover on... all the way through and nut em. But yeah, that end piece block is a no brainer, eh?
@readeracingRC Ай бұрын
i just reread you comment. i didnt realize you nut and bolted the plastic cover piece on. good idea. next time i tare it down in putting that to use,
@tuckerlutz5289 3 ай бұрын
Can you link to this part? Having trouble finding it
@readeracingRC 3 ай бұрын
wow. i don't see it on amazon anymore. but ebay item number 11563344458. called gpm steel transition input shaft cush drive 7786. shit and it $37 now.. jeeeeze. at the time it wasn't more than $20. have fan
Infinity Circus
Рет қаралды 7 МЛН
Sergio Outdoors
Рет қаралды 68 МЛН
Earl Moorhead
Рет қаралды 2,2 М.
its.maarten
Рет қаралды 10 МЛН