Thank you for being so thorough and informative. Awesome video! I refer to this video all the time! By the way Yamaha specifies in the owners manual that the main rear axle nut be torqued down to 108 ft. lbs.
@simeno5 жыл бұрын
Easy to understand and helpful. Thanks 👍
@jamesb88542 жыл бұрын
Good video, thanks
@Branstonburp5 жыл бұрын
Just got a puncture on my xsr🙄 video helpful! Thanks
@YamyHaw4 жыл бұрын
My tire popped flat barely 500 miles on my new 2018 😭
@ernieschatz3783Ай бұрын
Gotta get that louder exaust that sticks out like a wart cuz I gotta drown out the induction noise an show everyone that "Look errbody...lookie my exhaust. It looks so sick I wanna toss my cookies."
@Roy_Godiksen5 жыл бұрын
Tip: Use your foot to loosen the bolt. It's easier and saves energy and your back. 👍
@coltenmoore27972 жыл бұрын
Very helpful man thanks!
@tormodi59252 жыл бұрын
That axel nut was way to thight to begin with...My MT-10 has 190nm and that's not that stuck as your was.. Also important to remove the ABS sensor as first thing. It's one bolt. They are plastic and fragile and will extremely quickly be damaged by the wheel if not removed :)
@DaBinChe2 жыл бұрын
Think this was the first time removing them...seems like from the factory they are always tighter then what I use...I tend to use the lower end of the torque spec
@rommelsantos17874 жыл бұрын
Tip 1: don't damage that sensor so remove it before taking the wheel off. Don't let it near anything magnetic and some people say don't let it touch the sensor disk or you'll be buying a new sensor. Tip 2: take the caliper off completely. It'll be a bitch to reinstall if not impossible, so save yourself the hassle.
@bwxmoto6 жыл бұрын
I’m 195 lbs with a 15” breaker bar and can’t budge mine! Sheesh Yamaha! Over tightening these damed things. Time for some heat I guess.
@costofexpansebrain8025 Жыл бұрын
Whittle tab. 😂. Don't worry about it guy your all G
@MikeValentine855 жыл бұрын
Decent video my friend 👍
@TheMrChaddles5 жыл бұрын
Dude break the axle nut loose before you put it on the stand..
@windmillman6 жыл бұрын
Slow down video to understand Mr. Fastfire
@bwxmoto6 жыл бұрын
I can understand him fine
@robertod91495 жыл бұрын
I think he's got great pace but you can also adjust the video playback speed as you like.
@triv72527 жыл бұрын
108 ft Ibs torque for that nut.
@DaBinChe7 жыл бұрын
funny I have the service manual but never looked that up. It was very tight that I actually lifted the rear while trying to loosen it