xTool F1 Ultra Conveyor Review: Batch Engraving for Your Small Business

Рет қаралды 621

8 күн бұрын

xTool F1 Ultra + Conveyor: xtool.pxf.io/Y9ZZ2O
Conveyor only: xtool.pxf.io/75YY13
In this video, I show you the xTool F1 Ultra conveyor's batch engraving and large area engraving functions, as well as tips on how to solve problems that you may come across. The conveyor accessory helps the xTool F1 Ultra provide a higher-level user experience. As a laser craftsman, it is hard to say no to this super great product, but there are things you must know before buying it.
For more details and tips, please read my article: www.technicaltrendy.com/xtool...
00:24 xTool F1 Ultra conveyor assembly
01:38 How to use conveyor batch process in XCS software
05:04 Skipping recognition and engraving because of reflective surface
05:43 Non-reflective and regularly shaped materials can be placed at any angle
06:32 Different shapes of materials in the same batch engraving task are not supported
07:01 The problem of batch engraving reflective materials
08:38 The solution of batch engraving reflective materials
09:28 Failure to batch engrave black materials
09:56 Tip for batch engraving black materials
11:04 Use xTool F1 Ultra conveyor for large-area engraving

Пікірлер: 9

@TechnicalTrendy 2 күн бұрын

What aspects of this xTool F1 Ultra and Conveyor would you like to know more about?

@Shayiscoming 3 күн бұрын

really useful video, thanks for your revewing.

@TechnicalTrendy 3 күн бұрын

Thank you so much! Shay

@InnovateIgnite 4 күн бұрын

Batch engraving this solves a lot of repetitive operations, which is nice.

@TechnicalTrendy 4 күн бұрын

yes,it is suitable for mass producing small crafts

@Aria-so6sd 2 күн бұрын

Good review!

@TechnicalTrendy 2 күн бұрын

thank you so much, Aria!

@gregparker5732 5 күн бұрын

Someone should test the accuracy of the conveyor and camera. One test would be to cutout about a dozen 1" circles. Throw those on the conveyor and cut a 1/2" circle out of the center or each of them and measure the resulting ring width to see if it is 1/4" on all sides. Then throw those back on and cut the ring in a circle at 3/4" and see it you get two rings each being 1/8" wide. It could be done with squares in a similar manner or just fine lines repeated to see if the overlap perfectly.

@TechnicalTrendy 5 күн бұрын

good idea!