Your battery will last forever! We reanimate an OLD battery for portable INSTRUMENTS

Рет қаралды 209,557

26 күн бұрын

In our new video we reveal a 🗣️unique and amazing way to refurbish old batteries for portable tools such as screwdrivers. This method will not only help save your family budget, but will also play an important role in protecting the environment by reducing the amount of e-waste.
How the method works ❗️
Over time, tool batteries lose their ability to hold a charge due to inevitable chemical changes inside. However, if you have an old battery that no longer holds a charge and a fully charged, working battery, you can try reconditioning them. Connecting the two batteries will help rebalance the charge, which will temporarily restore the old battery's functionality.
Step-by-step recovery instructions❗️
1. Take an old faulty battery and a fully charged working one.
2. Connect them together using wires, observing the polarity: plus to plus, minus to minus.
3. Leave the batteries connected for a few minutes to an hour to allow the charge to flow from charged to discharged.
Why does this method work?❗️
When two batteries are connected, charge begins to flow from the more charged to the less charged. This helps restore the chemical balance inside the old battery, increasing its ability to hold a charge.
Important precautions:❗️
- Be careful: this method can be dangerous. Failure to do so may result in a short circuit or damage to the battery.
- Use protective gloves and goggles to ensure safety.
- Before starting work, check that the batteries are compatible in voltage and type.❗️🗣️

Пікірлер: 33

@user-mz4ig2tz6x 22 күн бұрын

*There is no problem if we proceed like this: give the batteries to a friend, tell them what needs to be done at place, then call them the next day to see if it worked. If they don't answer, or if a fire alarm is audible, then it did not work And finally, we can thank them for avoiding the problem at our place.*

@niewol5500 22 күн бұрын

Einen tiefentladenen Akku kurz anschieben, damit das original Ladegerät die Startspannung hat. Klappt, wenn keine Zelle defekt ist. Guter Tipp aber vorsichtig bei der Ausführung und immer beaufsichtigt laden! Danke und alles Gute.

@SweetCreative-nt1ep 10 күн бұрын

Your inventions are quite new to me, I will follow you.

@chucky47240 24 күн бұрын

Thanks for the tip! Good to know ! I have a battery that refuses to charge, I'm going to try to bring it back to life in the same way ! But this is troubleshooting, you will have to change the battery of the drill. If it can no longer charge, it is at the end of its life, its battery life will be short, and the same problem will return. In any case, with this tip, it allows you to continue using your drill while you buy a new battery. It's expensive depending on the brand, so this tip allows you to give yourself time to save money. 🤠🖖

@toaderviciriuc2249 16 күн бұрын

Ok felicitări ❤

@victoryfirst2878 23 күн бұрын

How batteries have this problems on a rough percentage FIX IT FAST ?? Thanks

@jantonio0099 23 күн бұрын

el problema es que con esto te va a permitir carga de nuevo pero en el sig descarga va a volvera pasar ya que lo que pasa es que la bms permite que d=se descargue mas de lo que debe

@hanssklorz 23 күн бұрын

Das sind dann die Akkus, welche man hier auf KZfaq spektakulär brennen sieht. Das tun die dann irgendwann in der Garage oder im Keller und nehmen schlimmstenfalls das ganze Haus mit. Kauft euch lieber neue Akkus. Die sind billiger als ein Auto, Haus oder das Leben.

@MetinTetiker 23 күн бұрын

Sayın Beyefendi Kardeşim. 12v aküden taşınan artı eksi uçlar ile yaptığınız bu şpklama işlemi diğer voltaj değerli şarjlı matkap aküleri içinde geçerli mi?

@healthyeatingwithasendler 22 күн бұрын

Evet öyle ama çok dikkatli olun! Pili uzun süre saklamaya değmez. Ve söyle bana, onu parçalara mı ayırdın? Tüm temas noktalarını bir multimetre ile kontrol ettiniz mi?

@MetinTetiker 22 күн бұрын

Hiç denemedim.Elimde 18v 2Ah.Einhell aküler var. Onları önce şarj edip durum değerlendirmesi sonrası sizin uygulamanızı denemeyi düşünüyorum.

@Fikry-Elfassakh 24 күн бұрын

ممتاز

@tibornagy3256 8 күн бұрын

Mne ukradli pri jednej montáži nabíjačku na starý parkside a teraz ju nemôžem nabiť dá sa to pravidelne vašim spôsobom robiť?

@healthyeatingwithasendler 7 күн бұрын

Nemôžete to robiť pravidelne! Pretože vaša nabíjačka sa mohla vypnúť, keď sa nabíjala, ale ako to teraz pochopíte?

@christiang.9485 22 күн бұрын

Also sorry, aber die Überschrift ist da Clickbait - von "reanimieren oder Batterie hält ewig" ist das meilenweit weg. Hier ist einfach nur der Akku tiefentladen, und das Ladegerät zu "blöd" das zu erkennen - deswegen lädt das Gerät den Akku einfach nicht. Und mit der Autobatterie wird quasi soweit vorgeladen, dass das Ladegerät merkt dass ein Akku angeschlossen ist - und dann mit der Ladung beginnt - mehr ist das nicht

@healthyeatingwithasendler 22 күн бұрын

Nein, in der Beschreibung habe ich klar beschrieben, wie und warum ich das mache! Bitte lesen Sie

@pw8526 2 күн бұрын

Stimmt habe einige damit wieder zum laden gebracht funktioniert 😉😁

@AlejandroTellez-om1lt 8 күн бұрын

No way!!!!!

@wernerpeter9706 23 күн бұрын

Why do you think deeply discharged lithium batteries are no longer charged by intelligent chargers? With your method you have: bypassed the safety circuit, no current limitation via the car battery, a battery that is reactivated at short term. In return, you get a weak battery with reduced capacity and current output (internal resistance increased). The cause of the failure, in over 90% an unbalance between the cells, was not eliminated. If you are already using a car battery, leave the lamp in the circuit as a limitation or use a laboratory power supply with a current limiter. From a safety perspective, this is still a big problem.

@MikeOrazzi 20 күн бұрын

I can never get this method to work on older Craftsman 19.2 volt batteries.

@wernerpeter9706 20 күн бұрын

@@MikeOrazzi Your 19.2V battery probably works with NiMh technology. There are 16 cells connected in series and some of them have probably already been polarized backwards. You can dispose of the battery and buy a new one or, better yet, buy a newer model. Apart from that, this method is extremely dubious, because with a 24V Li battery the voltage of the lead battery is too low and with an 18V Li battery it is at least borderline. If the Li battery has an internal protection module, it doesn't work anyway.

@MikeOrazzi 20 күн бұрын

@@wernerpeter9706 I gave up on the NiMh versions, but I do have a few lithium ion versions that won't take a charge. The ones that do work get rotated on the chargers when I think about it. I did buy an adapter that lets me use the new 20 volt batteries with my old 19.2 volt tools. So that thing is cool. I'm done buying the 19.2 batteries. Craftsman doesn't make them anymore. The China versions don't seem as good.

@wernerpeter9706 20 күн бұрын

@@MikeOrazzi When a Li battery is deeply discharged, processes begin that irreversibly change the cell chemistry. Chargers and/or batteries therefore have a protective circuit. It is unwise to avoid these. Normally the battery “only” loses capacity, no longer delivers such high currents and may have a higher self-discharge. Sometimes, but really very rarely, they get an internal short circuit that generates a lot of heat. This can happen immediately or many weeks later. I don't know of a charging adapter that switches from NiMh to Li-Ion or Li-Po. There are two completely different charging methods.

@seyyah3922 22 күн бұрын

Çok dikkatli olun ve degdirmel riniz anı olsun fazla tutmayın patlayqbilir çünkü yüksek akım vqr

@healthyeatingwithasendler 22 күн бұрын

Evet, bu bir lityum pil, dikkatli olmanız gerekiyor!

@muzaffercakmak8523 21 күн бұрын

Sakın ama sakın akü ile yapmayin.1 amper lik adaptör ile olur.. akü gibi güç kaynakları bu işler için hiç uygun değil

@viba882 24 күн бұрын

😮 ulala

@user-eu5vt7bk4v 8 күн бұрын

iki cihazdada verdiğiniz elektrik akımı birinde oluyorda diğerinde niye olmuyor ne alaka.ucları tutuyorsunuz deyinki düşük elektrikten çarpılmıyorum 220 volda böyle şey yapmayın çarpılırsınız diye tedbir amaçlı plastik terlik giyin .

@healthyeatingwithasendler 7 күн бұрын

Korumanız ve güvenliğiniz sizin elinizde! Bunu asla ihmal etmemek lazım haklısın