Good clear explanation from someone who knows. Thankyou.

Great video. Very well explained. Thank you. Had low power limp issue and helped in diagnosis

Very informative 😊👍

Wow boss excellent

Thanks brother for explaining the untold stories of skoda/vw cars. In rapid ,the vacuum control actuator was making some weird noise after switching off the engine. And only rarely it happens. Scanned but no issues found.. and there is no pick up issues also ..

Pls make more DIYs on vw

@yourDIYneeds please suggest good OBD for VW and other vehicles

Hi sir, thank you for informative videos on TDI engines. I have a 1.6l tdi CLN motor, it's throwing a p0407 engine fault code. What could be the problem?

Hi sir, thanks for one more valuable information for all vw owners Is their any lubrication process needed to this vnt flap actuator? Please let us know sir. . .

Please make video on safari engine vibration and cabin noise reduction, and overboost problem on 5th gear please sir

Hi, is it possible to have a small leak inside the actuator but still able to move actuator rod to open/close wastegate flapper? Thanks

Hi my 1.6 audi a3 has coil light flash then engine management light with code p2563. Is the fix to replace the vaccum pump or the accuator or sensor?

Hi thank you very for a good explanation on a complex vacuum system on a car. After replacement of the turbo by the workshop, my car went in limb mode no boost at all. After some research I discover someone has cut around 2cm of the pressure inverter hose into the wastegate which result in a big leakage. The engine does not run smoothly and h brake was hard. B diagnosting with Autophix i revealed short cut on the booster pressure solemoid. After replacing the hose and replacing the solenoid the vacuum system work again. Now the engine runs more smoothly and the brake works. Still I have the error 29A400 telling me the charging pressurre actuator closed too far/positive contol deviation. My car BMW 525D Xdrive 2012. I think the wastegate is done electronically, Do you know what kind of tools I must use to calibrate the wastegate prroperly?

Hello bhai, I have a vw polo 1.2 tdi, same warning sign glows as in your video when I hit 120km/ph or when I hit the gas a bit harder.. I replaced the Heater plugs already but that doesnt seem to be the problem, do you have any tips of suggestions of what it can actually be? Thanks for helping me out 🙏

My car goes to normal when I turn it off and back on. Is it possible the car is cutting the turbo because of an unrelated issue? Or is it an electrical issue in the turbo system? I replaced the maf and the map

Hello, I was wondering if you could possibly help me out I don’t make that much money and I’ve already putting a lot of money into my Volkswagen cc since I have gotten it the last few months I’m showing the P0299 code and the. Po420 .. not noticing a difference driving in the light goes on and off. Um, I thought I stopped hearing the turbo boost noise for a while but then I heard it today and the light was off from now the lights on. I’m gonna try to see if I can hear it. I’m not sure where to start. I do not have the money to bring it in a shop to work on it also got a couple scanners for Volkswagen ancel bd500 and vd700.. someone told me to start with the diverter valve. Maybe you could help me with some advice that would be great.

Hey bro in the obdeleven you have can we do injector minimum quantity adaptation? (where the engine keeps raising to 4k rpm for several minutes to learn pilot quantity of injection)

Bro vw polo 1.2 petrol main 0w40 mobil 1 oil use kar sakte hai

Hey I have a 2014 vento tdi .I notice since I got it, the brake pedal is very hard when I jump in a few minutes after I turned off ( 5 or 10) . Like a boost leakage but I don know if this is normal or not . It's not getting worst but I have it my mind

Hey buddy, i need small help to understand cost including labour cost approx cost. My safari 2.2 dicor 2012 dec . 45km run. Issue with front alighmnt left side gng. Machenic found few thing and suggested to replace , listed below. Lower arm bush kit Steering ball join LH and RH both. Lower and upper arm ball joint Break pad Upper arm and lower arm Wiper blade front only. Front shocker absorber. Please help to know approx cost. Will great help. Safari is maintained. No other issue.

Sir safari ke liye konsa engine oil best hai?

2015 Volkswagen Passat 2563, P00AF code. What should I check

Sir...r u having garage. ..if it so..where it is ..can u pls help ..am having the polo 2013...same problem am having .....near me..nopeople is not doing the mechanics properly

Hello sir plz suggest me which tool kit set is best for tata safari dicor

I have the code P2563 on my octavia 2.0tdi but it only comes when the engine is warm and is idling. The car runs fine and it has no boost problems. Is it possible that the vacum loss is so small that it makes error only on idle?

I am getting codes P2002, P0401, P2563, P2015… Any suggestions on what it might be? Any suggestions on where to start? It is in limp mode right now.

Hi, I think I am near å solution for my turbocharger . I have a pair of Booster Pressure Solenoids and a pair of Charger pressure ventiles. A set of 1 Booster pressure solenoid and a charger pressure ventile which control the low pressure turbocharger and a another set of 1 Booster pressure solenoid and a charger pressure ventile for the high pressure turbocharger. After replacing 1 Solenoid and 1 charger pressure ventile and replacing the turbocharger. The turbocharger seems to work. It last only 4 days. When the car is cold the turbocharger has a lot of lag and the turbocharger seems not working at all. After driving for 10-15 minutes and the engine get hot 80 degree or higher. I can turn off the engine and restart, the turbocharger work again for about 10 minutes and the turbocharger stops working again. I have read that this is typical fault on the solenoid and maybe the charger ventile as well. On saturday the workshop is going to replace both the solenoid and the charger ventile for the pressure turbocharger. After saturday I have totally replaced 2 solenoids 2 charger ventiles and 1 map sensor and of course the turbocharger too. I have also replaced the map sensor. The map sensor was completely glogged with oil and dust. The map sensor did not work and can not give suck pressure. The map sensor was supposed to give up to 4 bar. After replacing the map sensor all drive train errors dissappear and the lag on the engine dissappar too. Now there is no problem climbing hills on full speed.

Is it ok to blank egr of xuv500 1st gen?

I have the code p2563 on my 2012 polo 1.6 tdi... while driving the glow plug started flashing and immediately only can drive around 2000rpm in each gear... could it be a turbo needs replacing or the sensor?...if it's not the turbo ,how will you know if the turbo is not blown

Ive a 2.0 tdi with low boost limp mode.. Only comes on when going on a motorway, maybe after 65mph or 70mph, turn car off and on and it goes but it will keep coming back. What could thst be ? Dpf has been removed and its remapped by previous owner

Hey please helpp i am getting error code P029900 car giving white smoke on reverse gear or when need power it fails to give but according to mechanic turbo is okayy tf is happening with the car also it’s burning engine oil ?? Please reply asap

My booster control sensor show only 20 percent under the charge menu on my Autophix scanner. Sometime it show 100 percent , the percent change if i accelerate after i do a restart of engine, but mostly it shows only 20 present. The booster sensor is getting vacuum pressure from the vacuum control sensor, right? It is something wrong here, I think the booster control sensor should be steady at 100 percent to give enough pressure for the wastegate and actuator. Any comments?

Hi bro. My amarok has a flashing glow plug while running. How can I fix it?

Vaccum pipe from turbo is not sucking finger egr pipe is sucking easily in safari dicor 2.2vtt can we clean at home.

Hlo sir TATA SAFARI ke v koi apdate deo g please

Hi sir My car deshbord Have three light on last about one month can you help me out please first come DPF light after Two days GLOW plug light and engine light come on glow plug light flashing all the time can you help me about this my car VW TIGUAN 2011 model Diesel car thank you

sir meri vento 1.5 tdi ke injector me knowking sound bohat aa rha hai injector cleaner b try kiya ji..............jab subah car thandi hoti hai 1-2 din baad self marta hu tab bohat sound krte hai beech beech me skip marte hai jaise fuel na proper mil rha ho lekin jab gaadi 10-15 km chal ke grm ho jati hai tab engine ekdum silent ho jata hai new ki trah...........mechanic ne kha ke apke injector ki fuel timing hil gyi hai .. kya problem ho skti hai bhiya ji

Please Please help me. I have serious problem in my VW Vento 1.6 TDI 2012 model. Problem is , when i my car reaches exactly at 100kmph , there is sudden drop of pikcup and glow light comes on and car stops pickinh up. On scanning with OBD , there is this error PO299 , Turbocharger Underboost. Can you please tell me the fix ?

Hello, I have a golf 5 2.0 TDI 103kw 16V, 2004 year, I have repaired my turbo 3 days ago it was in terrible condition and I always had a problem of my car going into safe mode, I can drive it fast and give it full power but when I maintain a certain speed, let’s say 130km/h in 6th gear, after 15 - 20 seconds the car just goes into safe mode, it makes a weird whistle noise as if there is a hole in the pipes of the turbo but there is no holes.. If anyone can help I would be grateful.. I have it for 10 month’s and noone knows what is it.. Some say it’s because of throttle valve but I don’t know.

Hi dear sir the glow plug sign and engine management sign come every time and I have to take to mechanic every time can you advice me can do my self I spend money every time please if you have videos how to repair so I can try sir

Hi man i have code on my golf 7 2.0 Tdi 110 kw P2563,can u help ?

Bhaiya aapse contact kaise ho sakta hai?

Plz bro... Make a video on fault code p2425 (exaust gas recirculation cooling valve control circuit/open) this fault code shown in my vw vento 1.6 tdi.... But performance is good till now.

Sir silencer se burning smell aa rahi hai 1.6 tdi

Sir,fault code P256400 pls tell about this issue

I buy new Artilink 500 from this cod rider can I remove this sign 🙏

Vw vento 1.6 tdi engine down ka pta kaise chLta hai bhai ji

Tata Safari music sestem wearing

My car has difficult issue. When i start car vaccum is perfect bcz turbo actuator rod moving in actuator side then i shut off my car them its moving opposite of actuator but the problem is when i accelerate my car - actuator not move (No boost ( glow plug light also flashing) ) help me anyone

What is limp mode?

안녕하세요 대한민국에서 당신의 기술을 보고 글을 씁니다. 저는 어려움에 있습니다. 2013년식 아우디 2.0 TDI 이며 고장코드는 P0299 과급압력제어 로 인해 예열경고등이 점등되어 출력이 저하됩니다. 점검 방법과 수리방법이 도움이 필요합니다. 부탁합니다.