Yukon Denali (and other AWD) Drivers side motor mount replacement.

Рет қаралды 26,249

3 жыл бұрын

How can you tell if your motor mount is bad? In this video, I show you how I found out and also give feedback on some of the advice gained from other videos that I watched prior to taking on the job. This is a 2007 GMC Yukon Denali XL. Other GM vehicles will be similar.

Пікірлер: 23

@jayg479 3 жыл бұрын

I just helped my son do this tonight. Took us about 3ish hours and you nailed it on the head. Not hard but knuckle busting frustrating. “ watched the video after we finished “ lol

@KMLTimesTwo 3 жыл бұрын

That's awesome, lol! I think a 2nd set of hands definitively helped. Thanks for the comment.

@juanbriseno7816 2 ай бұрын

Thank you this video helped a lot

@herreracain Жыл бұрын

Man! Everything you said I lived.! My whole front is sore, dropping sockets, different wrench configurations. Even the getting halfway through it and thinking what did I get myself into.!! LOL good stuff!

@KMLTimesTwo Жыл бұрын

It was a major pain right???? Well, hopefully you got yours done.

@yohan-electwordofguardthem9173 Жыл бұрын

Well 💪🏾 Thank's 💪🏼 Just Got A GMC Blk Customize YUKON DENALI XL AND BOTH FRONT Mounts Have To Be 🔧 🪛🔩 Change 🧰 Now O.Y.E.S ✔️

@keoder Жыл бұрын

Did you have an air wrench? I can’t break the 3rd bolt (closest to the firewall) off the frame. We’re the other 4 into the block as difficult?

@victorpricejr 3 жыл бұрын

Should have called me brother. Would have given ya a hand with this. I love wrenching on trucks.

@KMLTimesTwo 3 жыл бұрын

That's great news because I need to do the other side! ;-)

@jacobkern9908 Жыл бұрын

Going in through the wheel well should be easier then on top of the engine

@KMLTimesTwo Жыл бұрын

Yes, some can get it that way. I did try that on both sides....I got close, but was not able to get it.

@acres90 2 жыл бұрын

Is the heat shield necessary?

@KMLTimesTwo 2 жыл бұрын

I think the older designs didn't have them and the heat cooked the fluid inside and hardened the rubber. I would keep them on if it were me.

@acres90 2 жыл бұрын

@@KMLTimesTwo got the old out yesterday...now to go back with new one

@KMLTimesTwo 2 жыл бұрын

@@acres90 Not sure if you tried at all yesterday, but getting it in....is a HUGE pain!!!!! Just know that going in and it will help, lol. Take your time and try many different ways, etc. You might try getting them both in at the same time if possible. I did one at a time and I think it may be easier with each one unbolted. That said, be careful doing that. I have never tried it and not sure if there is any negative to doing so.

@acres90 2 жыл бұрын

@@KMLTimesTwo I'll keep you updated

@acres90 2 жыл бұрын

@@KMLTimesTwo got'er done this evening...saved $1k... hopefully good for another 160k. Thanks for posting!!