yz250 transmission install

Рет қаралды 8,511

The Twostroke Rebuilder

3 жыл бұрын

Пікірлер: 16

@levierickson4368 5 ай бұрын

You made it look easy. Thanks

@eliblaine7711 Жыл бұрын

This just saved my bacon! I took out the trans thinking it would be easy to get back in, but I wouldn’t have been able to put the forks right without your help. Thanks for the tips

@thetwostrokerebuilder Жыл бұрын

Awesome 👍 thanks for watching 👊

@thetwostrokerebuilder Жыл бұрын

Watch my transmission inspection ones I'd recommend before putting back together 🔧🔧

@mrw1054 6 ай бұрын

Great vid.very helpful thank you!

@chadrides914 2 жыл бұрын

Good job. I’m getting my ass kicked on my 250x trans

@Aidans_Mx 10 ай бұрын

Are the forks marked ?

@thebigboomgaming1505 3 ай бұрын

i put my transmission in but it wont shift more than 3 times up or down and i only have 1-3 sometimes 3 doesnt even work, does the drum have to be in a certain way?

@thetwostrokerebuilder 3 ай бұрын

When it's together or just in a half? They don't shift good apart. Will when together tho.

@thetwostrokerebuilder 3 ай бұрын

Only goes together one way. Even together gotta spin shaft to get it to shift.

@thebigboomgaming1505 3 ай бұрын

fully together, its in the cases and doesnt want to shift more than twice @@thetwostrokerebuilder

@thebigboomgaming1505 3 ай бұрын

when i took the old transmission out it shifted trough all of them with no issue@@thetwostrokerebuilder

@thetwostrokerebuilder 3 ай бұрын

@@thebigboomgaming1505 spins freely? Sometimes gotta whack the shaft I bit with mallot cause gets up tight against bearing and binds. Other than that it's pretty simple trans long as you got clips and trust washers all in where go. If shifted fine before it should be fine. But I mean you should definitely be able to shift threw the gears even if it's a bitch. Worse case split back apart and start over