You can do this alot easier. Put spindle nut all the way on . Put small 3 jaw puller on end of axle. Run bolt in . Mine came right off.

15:47-16:00 😂😂😂😂

very useful, I wish I had seen this sooner.

There is a swing bolt on the drivers side of my truck that cant come out because of the control arms how did you guys work around this?

It appears you did not have to remove the spring when pulling the pumpkin?? I thought it was necessary to drop it low enough to get the pumpkin off?

Thought the front axles were Dana 35 (or a 28) with ten bolts holding it to the cross axle housing?

To be fair that outer spindle nut very commonly is loose upon tear down….we usually torque them closer to 200ft.Lbs

No they are not that hard to get off, that was how easy it is to take my spindle nuts off but I did make sure to torque the inside nut to 40 then back off a 1/4 turn to free the rotor and you put the center spacer then the outer which I left torqued to 40 so my spindle could spin the rotor center and free

So the drivers side is the floating side?

I got a massive leak on my 93 front axle I gotta do this now wtf