Thank you for your advice and sharing, I've watched many of your videos and learned a lot from them.

thanks for your comment, it has been replaced previously and currently no ingress of oil into the injector harness loom connector near the rocker cover nor in the two black/red ecu block connectors.

@@DanielJohnHowTo Ah, right. I replace the injector loom as part of a service, they aren't too expensive.

thanks for asking, they are 120 litre i believe 300 may be a mistake in the video.

depends on the paper/environment as well, for me it was 7k~ then i switched paper and problem hasn't returned

what do you want to know about it, we have done that job

I just wanted to have a reference video to watch before I tried removing and replacing broken one. Do you have one. If not, do I have to remove part of the dash to do it please.

@@MatthewCoyle-q3y We don't have a video at the moment, should have filmed one really. However the cable is easy to remove, under the passenger side dash there's a section with screws and hinged that makes it easier to remove/install the new cable that's the first piece of advice I can give. The cable is located at the back of the battery area and comes through via gromet, so you can use the old cable to pull the new one through or some wire.

Welcome

Thanks for sharing

there's other videos on the channel for those parts, this is just a video about that particular product

You can come out to my place and eat all the weeds you want. The ones you don't eat will get a good dose of Ortho Ground Clear.

possibly, but keep the hole small so it has a better chance of sealing that's all

i think you would need something a bit better, there's products that can be painted on

it has lots of different compounds etc, pva can be used to seal against moisture then primer and paint depending what you're doing