Good video about injector adjusting. Those small MF's are great tractors!
@stevefuller17793 жыл бұрын
I have worked on these engines for almost 50 years, never done a compression test, you can tell most faults with them just by looking and listening, in my experience the biggest problem for poor starting is injector pump needing attention. Some do seem to start better than others no matter what you do.
@smileypjau4 жыл бұрын
I have one of these, but without load the DC voltage is about 20v with 8v of AC ripple (not clean DC). The AC output without load is about 300v. Is this normal for these units? I was hoping for better regulation. Thanks, Pete
@badas95Z4 жыл бұрын
Where do you put the tester fitting? The injector port or what?
@ApexRKOPredator114 жыл бұрын
Yes in the injector port
@giemme44925 жыл бұрын
Hi, 370psi does not seem low... what was the diagnosis then? thx
@donlucio14 жыл бұрын
Exactly. I think it should be between 400 and 490 psi.
@ApexRKOPredator114 жыл бұрын
Bent con rod at number one cylinder
@ApexRKOPredator114 жыл бұрын
@@donlucio1 350 to 400 is perfect for a sh engine
@donlucio14 жыл бұрын
@@ApexRKOPredator11 Ok, thanks for an info.
@yaboygizzleyuppy66755 жыл бұрын
Sounds like the compressor is grounded from a freon leaking into a valves pissin...
@pl7476 жыл бұрын
Did you ever figure out what make./model compression tester you have?
@ApexRKOPredator116 жыл бұрын
Gday, no branding, just one i bought thru ebay
@pl7476 жыл бұрын
I have to do that same engine. What model tester did you use and where did you get it?
@mohamedfarid74997 жыл бұрын
fuck you i cant see the cage bar . why you make zoom out ? we could not see any thing