Saving me thousands of dollars in repairs!

"Just in case I spill some coolant" no punctuation needed. Is just gold

It is said that if you add more water to front loads, it diminishes the efficiency of the machine as it is not "calibrated" to accommodate a "manual" fill.

Hey I now have the whirlpool WFW94HEAW0 i got it used and I can’t find the screw to turn it down anywhere

Oh my gosh! Talk about SLOOOOOOWWWW!!!! IF somebody is that slow , they have NO business messing w/ ANYTHING!!

Thanks so much for for posting this awesome information video. Much appreciated

lucky me my mums washing machine always does high water level on final rinse like what i mean is it fills up to almost half way which is good

Hello! Thanks! How much coolant I need for engine and inverter? Thanks!

Fucking computer voices get dislikes.

Spark plugs were changed in my 2013 cmax hybrid sel but my engine light is still on my dash. But the codes were for the spark plugs. Do I need to reset it for the engine light to go off if so how?

Hey man, thanks for a very detailed guide, it`s a treasure. One question. How about draining the fluid radiator? or it is higher than draining screw?

There's a countable amount of water that's needed to dissolve a given amount of washing powder and an estimated amount of dirt. Using not enough water only leaves a residue of washing powder and dirt inside the fabrics and thus creates a need for a second washing (which wastes electrical energy). The same with rinsing - there has to be enough water to properly flush the said residues out of the fabrics (transport the molecules of the said residues). Insufficient water amount only makes it necessary to rinse twice or triple. Again: waste of electrical energy. The stupidly low water level in washing machines is an unscientific scam.

And thus the clothes' fabrics remain soaked in washing powder residue and dirt residue because rinsing uses too less water for proper flushing of the remaining molecules. Hence the need for double or triple rinsing. That's some water saving... ;)

Have someone done it in a whirlpools front load ?

Is the refill process required for inverter coolant as well like in this video or just for system coolant not inverter?

Will this work on a 2019 fusion hybrid and a 2013 fusion hybrid? I own 2 fusion hybrids.

Another AI ROBOT VOICE. I went to another video to find out how to do this.

thank you for this!

Can I add the same coolant that i use for the engine? I noticed the one you added to the inverter is orange as well.

Does any of the require the vehicle to be flat

Thanks for the video. Watched it right before doing work and changing plugs & air filter took about 90 minutes. Hardest part was getting the housing back on- you were correct in the rubber grommets being difficult. One thing that made the job easier was a 5/16" deep socket for the two outside cylinders in removing the ignition coils- watching you struggle with open ends was a little painful. Everything else went as planned and change out was smooth. Great job

Anyone on how to remove the pcv valve?

Do you have to drain befor adding.coolant? There is appx 3% fluid in my reservoir

I have a Bosch and can’t do it on mine be cause of a different valve without access to turn anything

1k whirlpool front washer won't clean my clothes because of its water saving feature i dump a 3 gallon bucket of water into the detergent dispenser tray during the wash cycle. ill try this

How is doing now that it has been 5 years?

Is it safe to simply add coolant if its low

This is eCVT so (2) electric motors and a tiny planetary gear set. That’s why so little transmission fluid. This is what makes these Ford transmissions as good as these from Toyota - it’s not a CVT with cone’n’chain.

I thought I bought the dry clean washer by mistake. After 5 years today I found your video. Now I have regular washer machine thanks. :)))))

Yes I had to do this to my brand new Samsung front loader 🎉

The factory puts red thread locker on there for a reason so you can’t adjust it. Not sure why 🤔 I stripped mine and now I have to replace the part 😂

What is with the goofy voices in these videos?

My machine fills and then stops after a few seconds. It donts wash. What could be the problem

#

Yo te go una ford escape hibrida 2009 , se calienta y se apaga , estaba viendo en un foro que puede ser la bomba electrica del anticongelante, sabes en que parte la lleva la escape hibrida 2009?

What was the code for inverter cooler. I got the code U019f??

Good job Thanks

Красень ! Маю такого тільки колір повністю Чорний 🐈‍⬛🙃

Thanks, good information to get me started on this project. One question is, would you recommend flushing fresh fluid through the transmission with the drain port open? I’ve heard that the internal filter is non serviceable so flushing might be the only way to get particles out of the system

How do I get it on extra rinse?

Hi, I have a 2019 Fusion Hybrid with 60,000 miles on it. Is it time to change the oil? What are the first symptoms of damage to the ECVT? Thanks;)

Why do you talk like a robot?

I learned everything I needed to felt confident enough after the video and the questions were perfect made and respond . Thank you for your help , let’s run this Ford fusión up to 500.000 ! 140 now and beautifully running

How is it now after 4 years

You put the whole red bottle of the flui transmission

That's still not enough water. The clothes can't get soaked and thoroughly cleansed in that pint of water :)

this looks like how much water my 2005 Duet FL washer uses after your modification...I think LG's use more water for rinses so the rinse level might be even higher than the wash... I think you chose a good level you do not want much more than that or it's starts rolling the load instead of lifting and dropping.

Hi, thank you for the video. Is this the MECS pump?

What is this for?

Did you have to disconnect hybrid high voltage for this? Is this what is considered a inverter coolant flush?