All that spraying without a mask 🙄

Moron

You learned from college, no talent

You don’t need the wheel off to do it

Minor fault but common

Little ex stream on the lock tight One ounce little overkill

Hier nicht > extrem > Mittelfest, eigentlich neue Selbstsichernde Mutter vorgeschrieben 😅😅😅 Extrem ? Öffnen > Extrem fest😢

Did it go faster lol, , I know I picked up about 5hp when I run it with the anti slip off ,

what year ?

It's criminal!!

I can’t believe you filmed that “repair” 😂

I would entrust such a repair to an expert. It is unthinkable for someone who lives in a block of flats.

임팩으로 적당히 조져

What about the inner side of the fender? It is stupid to just fix the outside when there is probably as much, or more rust on the inside.

Good video.

I did the same thing just differently. 😅

No matter what that carbon etc goes into the earth either by water,the ground or the air. Yet we get screwed with low performance and fuel efficiency just to capture it. 🤡🤡🤡

If that was easy then I would hate too see hard

Very Nice Job 👊

SI SONO EVOLUTI, ESISTE L'ESTRATTORE,

Thanks a lot!

Nobody will do that shit on a fender that cost $100 new

Why are you using loctight?

The rust needs to be sorted from the rear if the pannel as well.

A useful video that shows the key points and shows there are no complications to work around. The exhaust spec changed mid 2012 with the only difference appearing to be the position of the joint between the centre pipe and rear box. Anyone know if early and late ones are interchangeable (when both parts fitted) ?

Здесь уже вырезать надо

Please for heaven's sake, tell me there's no CarFixDifficult out there!

😂

I bet this guy can frost a cake better than Martha Stewart

If you change the stereo to a new 3rd party one and you get the error where you need to put the car code, what to do?

🤦🤦🤦🐏

Thankyou for that. Very useful.

This repair last one year max. Bubbling mean rust is also behind the panel. Only thing helps is cut out rusted section and weld new patch there. Don't waste your time for such fixes they don't last. This part/ panel is easily replaceable, just order new panel and paint it to orig color. I know because I have already done this all :). Cheers!

That’s what they call it (balls hit)….are you serious (crazy)….😖😖😖😖😖😖

😂😂 what a load of BS😂😂 it has to be cut out and a new piece welded in!

What a horrible repair job.😱

Thank youuu

Wrong locktight

✝️🚗

На 1.9 bkc становиться сцепление по оригиналу, маховик 037105273C, сцепление Sachs усиленное 3000332001, комплект болтов на маховик Sachs 3096005000, болты на корзину Volkswagen OE N10101001, направляющая Sachs 3114 600 007... Это будет намного надёжнее чем непонятные заменители

I need help real bad I have 2 rust spots in the front of my car, ? Is there a way that I can send you photos of the rust spots I have to you somehow yes or no?

Great video

Very clear and detailed video 👌🏽I can doit by myself now ! thank you !🙏🏽

I'm painting four many years without ressperater

too much effort for the small job.

3 Months and it looks same😂😂😂😂 ....

Good video. Use a mask though, buddy.

If it was so easy.......

This is amazing you sir are a legend

U can’t put bondo over primer. Why do u need infrared lamp