Someone else did the same build a couple years ago but with narration if you are still interested. kzfaq.info/get/bejne/kMBgY8d0q76tiI0.html

The final dimensions of the chair are: Total height = 128 cm; Total depth = 90 cm; Total Width = 71 cm; Seat height = 44 cm; Armsupport height = 71 cm. I suggest you run it through a converter yourself, since you probably have a better understanding of the imperial units than I have. For the back of the chair I actually used a thin sheet (2,5 mm according to the home improvement store) of MDF. I felt that plywood was not bendable enough to get it into such a tight curve. The supports for the bended MDF are Plywood though and for those I used beefy 18 mm plywood (I used hardwood plywood, look for "18mm - Sande Plywood ( 3/4 in. Category x 4 ft. x 8 ft.; Actual: 0.709 in. x 48 in. x 96 in.)" at Home Depot) and I would even suggest going with a thicker kind if possible.

I' am not a professional nor have I had any formal training. So YES, you can do try this too and if anything, learn a lot while doing! 💪

@@decooworks1315 thank you)

Это вообще станный метод изготовления кресла🙈

@@user-sy9uc1oe9q главное что это рабочий метод, и как мы видим очень успешный. Я восхищаюсь его старанием)