website doesnt have any merv10 stuff i cant even find this shroud? this video is only a year old wth?

Thank you for the video. Watched twice once to run through and second to go along step by step. Took about 45 minutes and cranked right up.

A little clarification at 8:06, the yellow wire from the soft start unit goes into the spot where you unplugged the white wire from the run capacitor

Hi, Is there an installation video available for the Aqua-Hot Gen1 gas and diesel system?

Can I have a heat strip with this installed ?

The video helped so much!!! THANKS FOR YOUR TIME TO MAKE IT!!

The heat element I purchased looks to have a 2 pin with a female connector and the ducted wall control box also has a female connector. In other words, the connector fits together, but the wires don’t actually connect. How do you deal with this?

I wish you would do a video of your soft start and Coleman heat pump. I bought it 2 years ago and still haven’t installed it. I would return it if I could thank you

I bet he's one hell of a poker player.

One of he clearest and most thorough installations I've ever see and used. Great job thanks!

Is it still working after 9 months? I tried Vaseline but it was stuck again in the morning, but in the afternoon it unstuck itself. I assume it was the sun's heat... It was way above freezing in the morning so I'm a bit confused as to why it was stuck in the morning but not the afternoon.... :S

Can you give me the part number for this water heater?

This video just basically shows how ineffectively the griddle heats up. Your griddle should have discoloration all over the base

I cannot find anything on this also.

May I use coconut oil or olive oil?

Just installed it! Wires were exactly like the video. Easy install! No clunk!

Thank you for this!

If the heat coil comes loose and touches the ac coil will it short out and ruin the capacitors?

Will be looking to change the top handle to a metal one that folds flat for transportation. Will also be looking to buy a backup dial since this one sticks out and looks like it might be easy to lose or break. Just purchased this and am looking forward to using it this summer! Great video - thanks!

What about the grille that has the 12x12x1 filter in it??

Thanks for the guidance. One question I had while attempting to remove chamber was the hose in the upper right corner. Can that be removed without losing fluid? Thanks, Bill

You should have said, "It reduces the starting current up to 75%" and not just reduces the current which is an incorrect statement.

Why wouldn't you flush out the tank while you have the anode rod out? I'm sure there is a lot of debris in the tank or is that in another video? It wouldn't hurt to say that though.

Can’t find any information on this return air grill. Dealers are clueless as is anyone at Coleman when I have inquired.

What about a wall thermostat controller

I installed this on all 3 of my AC today. First one took a bit, but by the 3rd one it was a 5 minute job. Now I won’t need to worry about tripping the genny breakers when 2 units cycle on at the exact same time. (Rare) or when trying to start all 3 in extreme heat. Before it was like an Apollo 13 start up sequence to get all 3 going when over 100 out. It was 102 today and the genny didn’t even surge.

For those outside the US & Canada, a 3/4 inch plug is hard to find so I have just cut off the remaining anode stem from a fully depleted anode rod. Also, the Mineral Oil being used is called "Paraffin Oil" or "White Mineral Oil"

Hello i installed one of these and it works great! After adding a heat strip it doesn’t heat it seems like it’s just blowing ac. Any idea?

Great video! Just finished my first service on a 250D. Greatly appreciate AquaHot being so open to DIYers! Here in California its not only incredibly expensive to service these things, but the wait times are OUTRAGEOUS. Had this knocked out myself in an hour!

Just want to convey my appreciation for being DIY friendly

Very easy install thanks to your video!!

I'm getting a mini split, I've had it with these inefficient camper a/c,

The Coleman Machs are terrible units. Broken fan blades and crack copper pipe is very common. Absolutely hate mine.

What about the outsides, back side, and bottom?

Can you tell me where to find these filters? Having an issue locating

These things are junk. Base pan is made of fibreglass and is very prone to breaking. Very difficult to fix a crack or break in the stuff. Don't buy. HR sucks

Its great to see the big shot doing the job and showing the customers how it's done. Thank you

I installed this in conjunction with the Bluetooth controller. However it does not get hot and the output where the element plugs in shows about 48 vac. What is the Problem??

Is there a way to change the hose so that it can connect directly to an RV via a quick connect, so that you don’t have to bring along a separate propane tank? Or can can you get a longer hose, to hook directly to one of the RV’s propane tanks?

Howdy! Can this conversion kit be used with the ccc2 thermo? Can the ccc2 be changed out for the CT? If not is here a kit that will use my existing setup?

I have a Coleman AC model 8333B876 with a heating strip. Will the older model ceiling assemble and heating strip work with 48203-066 replacement?

Looks like the new intake without the dumps bolts right up. Can we buy that piece to convert our standard Mach 15 to the new residential style filters?

Does the temp knob actually work as a thermostat or is the heat just always on? So could you just test till you found a sweet spot of say 72º or so

Some recent 45*** units have a start capacitor with red, yellow AND black wires. You are supposed to move the red and yellow wires but the enclosed documentation doesn’t say what happens to the black wire when you remove the start capacitor. I tried just taping it off but my install doesn’t work. The compressor doesn’t come on. Tried emailing Coleman twice for help but no reply. Any ideas folks?

I mounted the soft start right above the capacitors in the cabinet. Never had to remove wires from the compressor. I just connected all the wires in the cabinet with high quality insulated crimp on nylon quick connects. Far easier. I didn't have to pull any wires through the cabinet seal. Update: On the hottest day at the track, 95 deg plus, last month the softstart failed to start the compressor. I shut down and tried it after waiting half an hour several times. No go. I tried it again the next day when it was down to 85 deg, and it worked fine. Not happy. My AC worked perfectly before I installed this. It worked perfectly for a few months as I was testing it getting ready to travel.

Great video... thanks for the help. I installed one today. I happen to have the exact same model (48xxxxxxx) and so it was an easy install. Nice to know I can now run my AC with my Honda 2200 inverter generator or from a home outlet.

good video, easy to follow

Please make a video for heat pump installation. Many new rv’s have them. I bought this product and need more info

Will this work for Dometic units on 2019 wolf pup 18TO?

Followed these directions and was done in 30 minutes. Plugged rv into 20 amp gfci circuit and a/c started up with no issues. I will miss that CLUNK at start up! 🎉